FireCADCalc

Gas Solubility in Water by Henry's Law

Equilibrium mole fraction and concentration of a dissolved gas in water from its partial pressure and Henry's law constant, in mg/L.

Refinery and petrochemicalChemical and fertiliserFood, dairy and textile

Inputs

Examples: Oxygen from air at 25 °CCO2 at 1 bar, 25 °C

From a table for the gas at the water temperature; units of pressure per mole fraction.

Results

Dilute solutions only; concentration taken per m³ of water at 1000 kg/m³.

Mole fraction in water4.9830e-04%
Concentration8.8509mg/L

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Oxygen from air at 25 °C. The inputs, in the units selected above:

InputValue
Partial pressure of the gas21.228 kPa
Henry's constant (pressure per mole fraction)4,260.0 MPa
Molar mass of the gas31.999 kg/kmol

Applying the formula below gives:

ResultValue
Mole fraction in water4.9830e-04 %
Concentration8.8509 mg/L

Open this example in the calculator and change any input.

Formula

\(x_i = \frac{p_i}{H}, \quad c = \frac{x_i}{1 - x_i}\cdot\frac{M}{M_w}\rho_w\)

Variables

Symbol Meaning SI unit
\(p_i\) Partial pressure of the gas Pa
\(H\) Henry's constant (pressure per mole fraction) Pa
\(M\) Molar mass of the gas kg/kmol
\(x_i\) Mole fraction in water -
\(c\) Concentration kg/m³
\(M_w\) Molar mass of water, 18.015 kg/kmol
\(\rho_w\) Density of water, taken as 1000 kg/m³

Method and standards

Henry's law.

Where it is used

  • Dissolved oxygen and CO₂ in boiler feedwater.
  • Stripping and aeration.

Common mistakes

  • Mixing Henry constant forms (pressure per concentration vs per mole fraction).
  • Total instead of partial pressure.

Assumptions and limits

  • Dilute, non-reacting gas.
  • ρ_w = 1000 kg/m³ and M_w = 18.015 kg/kmol are fixed: the concentration is per m³ of water at 1000 kg/m³ (at 60 °C real water is about 1.7 % less dense).
  • Henry's constant must be at the water temperature. For O₂, N₂, CO₂ and other common gases the dissolved gas saturation calculator takes it from IAPWS G7-04 directly.

References

  • Henry's law p_i = H x_i (dilute solutions)

Questions and answers

Oxygen from air into water at 25 °C (H about 4.26 × 10⁹ Pa)?

About 8.9 mg/L, close to measured saturation.

Why does warm water hold less?

H rises with temperature.

Deaerators?

They lower the partial pressure of oxygen above the water, so dissolved oxygen falls.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.