FireCADCalc

Diluting a Concentrated Acid or Alkali (Mass Balance)

Volumes of concentrated acid or alkali and water to make a dilute solution, by mass balance with the densities of both solutions, since volumes do not add.

Refinery and petrochemicalChemical and fertiliserFood, dairy and textile

Inputs

Examples: 10 % sulphuric acid from 98 %4 % caustic from 48 %

From the maker's or a handbook density table.

Results

Add the concentrated acid or alkali to the water slowly, with stirring and cooling; never water to the concentrate.

Mass of concentrated solution108.78kg
Volume of concentrated solution59.246L
Mass of water957.22kg
Volume of water959.14L

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 10 % sulphuric acid from 98 %. The inputs, in the units selected above:

InputValue
Strength of the concentrated solution (mass fraction)98.000 %
Density of the concentrated solution1,836.0 kg/m³
Strength wanted (mass fraction)10.000 %
Density of the dilute solution1,066.0 kg/m³
Volume of dilute solution wanted1,000.0 L
Water density998.00 kg/m³

Applying the formula below gives:

ResultValue
Mass of concentrated solution108.78 kg
Volume of concentrated solution59.246 L
Mass of water957.22 kg
Volume of water959.14 L

Open this example in the calculator and change any input.

Formula

\(m_2 = \rho_2 V_2, \quad m_1 = \frac{w_2}{w_1} m_2, \quad m_w = m_2 - m_1\)

Variables

Symbol Meaning SI unit
\(w_1\) Strength of the concentrated solution (mass fraction) -
\(\rho_1\) Density of the concentrated solution kg/m³
\(w_2\) Strength wanted (mass fraction) -
\(\rho_2\) Density of the dilute solution kg/m³
\(V_2\) Volume of dilute solution wanted m³
\(\rho_w\) Water density kg/m³
\(m_1\) Mass of concentrated solution kg
\(V_1\) Volume of concentrated solution m³
\(m_w\) Mass of water kg
\(V_w\) Volume of water m³

Method and standards

Mass balance.

Where it is used

  • DM plant regeneration chemicals.
  • Laboratory reagents.

Common mistakes

  • Volume percentages for mass percentages.
  • Ignoring heat of dilution.

Assumptions and limits

  • Densities at the same temperature.

References

  • Solute mass balance w₁m₁ = w₂m₂ with solution densities

Questions and answers

1000 m³ of 10 % H₂SO₄ from 98 %?

Per litre: 59.2 mL of acid in 959 mL of water.

Why not C₁V₁ = C₂V₂ in %?

Percentages are by mass and volumes are not additive: the mixture shrinks and heats.

Safety?

Acid into water, slowly, with cooling and full PPE.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.