Worked example
Example: Benzene-toluene at 95 °C. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Component 1 (light): A | 6.9056 - |
| Component 1: B | 1,211.0 - |
| Component 1: C | 220.79 - |
| Component 2 (heavy): A | 6.9546 - |
| Component 2: B | 1,344.8 - |
| Component 2: C | 219.48 - |
| Temperature | 95.000 °C |
| Pressure (absolute) | 101.33 kPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Vapour pressure 1 | 156.90 kPa |
| Vapour pressure 2 | 63.578 kPa |
| K-value 1 (ideal) | 1.5485 |
| K-value 2 (ideal) | 0.62746 |
| Relative volatility | 2.4678 |
Open this example in the calculator and change any input.
Formula
\(\log_{10} p^{sat} = A - \frac{B}{C + t}, \quad K_i = \frac{p_i^{sat}}{p}, \quad \alpha_{12} = \frac{p_1^{sat}}{p_2^{sat}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(A_1\) | Component 1 (light): A | - |
| \(B_1\) | Component 1: B | - |
| \(C_1\) | Component 1: C | - |
| \(A_2\) | Component 2 (heavy): A | - |
| \(B_2\) | Component 2: B | - |
| \(C_2\) | Component 2: C | - |
| \(T\) | Temperature | K |
| \(p\) | Pressure (absolute) | Pa |
| \(p_1^{sat}\) | Vapour pressure 1 | Pa |
| \(p_2^{sat}\) | Vapour pressure 2 | Pa |
| \(K_1\) | K-value 1 (ideal) | - |
| \(K_2\) | K-value 2 (ideal) | - |
| \(\alpha_{12}\) | Relative volatility | - |
Method and standards
Antoine and Raoult.
Where it is used
- Distillation shortcut design.
- Flash K-values.
Common mistakes
- Constants in a different unit form.
- Outside the valid range.
Assumptions and limits
- Ideal liquid and vapour.
- Antoine constants in the mmHg and °C form, log₁₀(p/mmHg) = A − B/(C + t/°C); the bubble and dew point page uses the bar and K form instead.
- The defaults are a commonly tabulated benzene and toluene set; each set holds only over its own temperature range, which the page does not check.
References
- Antoine equation log₁₀p = A − B/(C + t); Raoult K = p_sat/p; α = p₁_sat/p₂_sat
Questions and answers
Benzene and toluene at 95 °C?
α about 2.47.
Where are Antoine constants?
Property handbooks; check the units and range.
Non-ideal mixtures?
Multiply by activity coefficients (see Margules).
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.