FireCADCalc

Packed Absorber: Transfer Units (Colburn) and Height

Number of overall gas-phase transfer units of a packed absorber by the Colburn equation for a straight equilibrium line, and the packed height from HOG.

Sugar mill and cogenerationRefinery and petrochemicalChemical and fertiliser

Inputs

Examples: 2 % to 0.1 %Lean solvent

From the packing maker or a correlation.

Results

Stripping factor mG/L0.80000
Transfer units8.6138
Packed height6.8911m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 2 % to 0.1 %. The inputs, in the units selected above:

InputValue
Solute in the gas entering2.0000 %
Solute in the gas leaving0.10000 %
Solute in the liquid entering0 %
Equilibrium slope y = mx1.2000 -
Liquid-to-gas molar ratio1.8000 -
Height of a transfer unit0.60000 m

Applying the formula below gives:

ResultValue
Stripping factor mG/L0.66667
Transfer units5.9773
Packed height3.5864 m

Open this example in the calculator and change any input.

Formula

\(N_{OG} = \frac{1}{1 - \lambda}\ln\left[(1 - \lambda)\frac{y_1 - m x_2}{y_2 - m x_2} + \lambda\right], \quad \lambda = \frac{mG}{L}\)

Variables

Symbol Meaning SI unit
\(y_1\) Solute in the gas entering -
\(y_2\) Solute in the gas leaving -
\(x_2\) Solute in the liquid entering -
\(m\) Equilibrium slope y = mx -
\(L/G\) Liquid-to-gas molar ratio -
\(H_{OG}\) Height of a transfer unit m
\(\lambda\) Stripping factor mG/L -
\(N_{OG}\) Transfer units -
\(Z\) Packed height m

Method and standards

Colburn.

Where it is used

  • Packed scrubbers and strippers.
  • Flue gas and vent scrubbers.

Common mistakes

  • Mass ratios for molar.
  • H_OG outside the packing's range.

Assumptions and limits

  • Dilute, isothermal, straight lines.

References

  • Colburn (1939) N_OG for straight equilibrium and operating lines; Z = H_OG × N_OG

Questions and answers

2 % to 0.1 % with m 1.2 and L/G 1.8, H_OG 0.6 m?

N_OG about 5.98: some 3.6 m of packing.

Transfer units vs stages?

They are equal only when the lines are parallel (λ = 1).

Add margin?

Add for distributors and uncertainty in H_OG.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.