Worked example
Example: Dilute absorber. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Gas molar flux, kmol/(m²·s) | 0.030000 - |
| Liquid molar flux, kmol/(m²·s) | 0.15000 - |
| Gas-film coefficient, kmol/(m³·s) | 0.060000 - |
| Liquid-film coefficient, kmol/(m³·s) | 0.80000 - |
| Equilibrium slope (y = mx) | 1.5000 - |
| Overall gas transfer units | 6.0000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Gas-film HTU | 0.50000 m |
| Liquid-film HTU | 0.18750 m |
| mG/L | 0.30000 |
| Overall gas HTU | 0.55625 m |
| Packed height | 3.3375 m |
Open this example in the calculator and change any input.
Formula
\(H_G = \frac{G_m}{k_ya}, \quad H_L = \frac{L_m}{k_xa}, \quad H_{OG} = H_G + \frac{mG_m}{L_m}H_L, \quad Z = H_{OG}N_{OG}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(G_m\) | Gas molar flux | - |
| \(L_m\) | Liquid molar flux | - |
| \(k_ya\) | Gas-film coefficient | - |
| \(k_xa\) | Liquid-film coefficient | - |
| \(m\) | Equilibrium slope (y = mx) | - |
| \(N_{OG}\) | Overall gas transfer units | - |
| \(H_G\) | Gas-film HTU | m |
| \(H_L\) | Liquid-film HTU | m |
| \(\lambda\) | mG/L | - |
| \(H_{OG}\) | Overall gas HTU | m |
| \(Z\) | Packed height | m |
Method and standards
Two-film theory.
Where it is used
- Absorber and stripper sizing.
- Scrubber height checks.
Common mistakes
- Mixing mass and molar fluxes.
- Using coefficients for another packing size.
Assumptions and limits
- Dilute; straight equilibrium line.
- Fluxes and coefficients are plain numbers in kmol/(m²·s) and kmol/(m³·s), with no unit lists; they must share the kmol basis, or the HTU is out by a factor of 1000.
References
- Perry's Chemical Engineers' Handbook
- 9th ed. (McGraw-Hill, 2019)
- sec. 14 (H_OG = H_G + λH_L)
Questions and answers
Why add λ·H_L to H_G?
The overall resistance is the gas film plus the liquid film seen from the gas side; the liquid part is scaled by the slope mG/L.
What HTU is typical?
0.3–1 m for random packing in absorption; less for structured packing.
What do the defaults represent?
A dilute gas absorber with mostly gas-film control.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.