FireCADCalc

Biomass Ash Alkali Index (Fouling Tendency)

Alkali index in kg of K₂O + Na₂O per GJ from the fuel's ash, the alkali oxides in the ash and the calorific value, with the published fouling thresholds.

Sugar mill and cogenerationDistillery and ethanolPulp and paperBoiler

Inputs

Examples: Rice huskBagasseStraw

Results

Above 0.34 kg/GJ: fouling and slagging virtually certain (Miles et al.).

Alkali index (kg alkali oxides per GJ)0.36458kg/GJ

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Rice husk. The inputs, in the units selected above:

InputValue
Ash % fuel (as fired)18.000 %
K₂O % ash2.0000 %
Na₂O % ash0.50000 %
Fuel GCV (as fired)13,500 kJ/kg

Applying the formula below gives:

ResultValue
Alkali index (kg alkali oxides per GJ)0.33333 kg/GJ

Open this example in the calculator and change any input.

Formula

\(AI = \frac{A\,(K_2O + Na_2O)}{GCV}\)

Fouling probable for \(0.17 < AI \le 0.34\) kg/GJ; virtually certain above 0.34 kg/GJ.

Variables

Symbol Meaning SI unit
\(A\) Ash % fuel (as fired) -
\(K_2O\) K₂O % ash -
\(Na_2O\) Na₂O % ash -
\(GCV\) Fuel GCV (as fired) J/kg
\(AI\) Alkali index, shown in kg of alkali oxides per GJ (1 kg/GJ = 10⁻⁹ kg/J) kg/J

Method and standards

The alkali index of Miles, Miles, Baxter, Bryers, Jenkins and Oden, Alkali Deposits Found in Biomass Power Plants (NREL, 1995–1996): the mass of K₂O + Na₂O brought in per GJ of fuel heat, with their thresholds of 0.17 kg/GJ (fouling probable) and 0.34 kg/GJ (fouling and slagging virtually certain).

Where it is used

  • Fuel selection.
  • Boiler design for biomass and slop.

Common mistakes

  • Ash % of dry fuel with as-fired GCV.

Assumptions and limits

  • Same basis for ash and GCV (both as fired, or both dry); the index is per GJ of gross (higher) heating value. The code cannot check the basis.

References

  • Miles et al. (1995/1996)
  • alkali deposits in biomass power plants (NREL): AI = (K₂O + Na₂O) in kg per GJ of fuel; thresholds 0.17 and 0.34 kg/GJ

Questions and answers

Why alkali?

Potassium and sodium form low-melting deposits on superheaters and the furnace.

Bagasse vs straw?

Bagasse is usually moderate; straw, husk with high potassium and slop are severe.

What to do when it is high?

Lower furnace exit temperature, wider tube spacing, more soot blowing, or blending.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.