Worked example
Example: 2 bar steam, 25 mm tubes. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Steam pressure (absolute) | 2.0000 bar |
| T_sat − T_wall | 8.0000 K |
| Tube outside diameter | 25.000 mm |
| Tubes in a vertical row | 10.000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Coefficient, single tube | 13,917 W/(m²·K) |
| Mean coefficient, row of N tubes (N^−1/4) | 7,826.4 W/(m²·K) |
| Heat flux, single tube | 111.34 kW/m² |
Open this example in the calculator and change any input.
Formula
\(h_1 = 0.729\left[\frac{g\rho_l(\rho_l - \rho_v)h'_{fg}k_l^3}{\mu_l \Delta T D}\right]^{1/4}, \quad h_N = h_1 N^{-1/4}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(p\) | Steam pressure (absolute) | Pa |
| \(\Delta T\) | T_sat − T_wall | K |
| \(D\) | Tube outside diameter | m |
| \(N\) | Tubes in a vertical row | - |
| \(h_1\) | Coefficient, single tube | W/(m²·K) |
| \(h_N\) | Mean coefficient, row of N tubes (N^−1/4) | W/(m²·K) |
| \(q\) | Heat flux, single tube | W/m² |
Method and standards
Nusselt.
Where it is used
- Condensers, juice heaters and steam heaters.
- Teaching condensation.
Common mistakes
- ΔT taken as steam minus cooling water.
Assumptions and limits
- Laminar film, pure vapour.
- Liquid properties at saturation. Incropera (and the vertical-surface calculator here) take them at the film temperature (T_sat + T_wall)/2; for large ΔT the two differ by a few per cent.
References
- Nusselt film theory for a horizontal cylinder
- h = 0.729 [g ρ_l(ρ_l − ρ_v) h′_fg k³/(μ ΔT D)]^¼
- h′_fg = h_fg + 0.68 c_p ΔT
- row of N tubes × N^−¼ (Incropera); properties from IAPWS-IF97
Questions and answers
Why does the coefficient fall down a tube row?
Condensate from upper tubes thickens the film on lower ones.
Why add 0.68 c_p ΔT?
It accounts for sub-cooling of the condensate film (Rohsenow's modification).
Air in the steam?
Even a small amount of air blankets the tubes and cuts the coefficient a lot.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.