Worked example
Example: 10 t/h saturated at 10 bar g in DN150 sch 40 (154.1 mm). The inputs, in the units selected above:
| Input | Value |
|---|---|
| Steam flow | 10,000 kg/h |
| Steam pressure (shown as gauge) | 10.000 bar g |
| Steam condition | Dry saturated |
| Steam temperature (superheated only) | 250.00 °C |
| Pipe inside diameter | 154.10 mm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Steam velocity | 26.396 m/s |
| Volume flow | 1,772.3 m³/h |
| Specific volume | 0.17723 m³/kg |
| Density | 5.6423 kg/m³ |
Open this example in the calculator and change any input.
Formula
\(\dot V = \dot m\,v_s \qquad v = \frac{\dot V}{\pi D_i^2/4} \qquad \rho = \frac{1}{v_s}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot m\) | steam flow | kg/s |
| \(p\) | steam pressure | Pa |
| \(\text{state}\) | saturated or superheated | – |
| \(T_s\) | steam temperature | K |
| \(D_i\) | inside diameter | m |
| \(v\) | velocity | m/s |
| \(\dot V\) | volume flow | m³/s |
| \(v_s\) | specific volume | m³/kg |
| \(\rho\) | density | kg/m³ |
Method and standards
Continuity with IAPWS-IF97 specific volume.
Where it is used
- Checking existing mains after load growth.
- Noise and erosion complaints.
- Choosing control valve and meter sizes.
Common mistakes
- Using nominal diameter.
- Using gauge pressure as absolute.
- Forgetting the lower pressure at the far end.
Assumptions and limits
- Dry steam; velocity at the stated pressure only. Wet steam cannot be entered.
- The 60 m/s warning is a screening level of this page, not a cited limit, and applies to both states; saturated mains are usually kept lower.
- The pressure is shown as gauge in every unit system (bar g, kg/cm² g, psig).
References
- IAPWS-IF97
Questions and answers
How fast does 10 t/h of saturated steam at 10 bar g move in DN150?
26.4 m/s in 154.1 mm bore (specific volume 0.177 m³/kg).
What velocity is right?
Your piping specification sets it; saturated mains are usually kept lower than superheated lines to limit erosion by droplets.
Why does velocity rise along a main?
Pressure falls, so specific volume rises.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.