FireCADCalc

Dry-Crushing (First-Mill) Extraction (Hugot)

Juice and sugar extraction of dry crushing from fibre in cane and bagasse (Hugot 19.3–19.4), his empirical estimate (21.6) and juice-analysis method (21.3).

Sugar mill and cogeneration

Inputs

Examples: Typical first millHigh fibre

Hugot: 1.05–1.10.

Results

Queensland finds 1 % more first-mill extraction gives about 0.10–0.12 % more total extraction.

Juice extraction by dry crushing63.025%
Sugar extraction by dry crushing66.176%
Empirical estimate 1 − 0.06/(0.34 − f)66.667%
Share of mixed-juice sugar in primary juice70.833%
Primary juice extraction from juice analyses66.583%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Typical first mill. The inputs, in the units selected above:

InputValue
Fibre per unit cane14.500 %
Fibre in first-mill bagasse33.000 %
Sugar/juice extraction ratio1.0700 -
Sugar % primary juice18.000 %
Sugar % secondary juice10.000 %
Sugar % mixed juice14.000 %
Total extraction of the tandem95.500 %

Applying the formula below gives:

ResultValue
Juice extraction by dry crushing65.568 %
Sugar extraction by dry crushing70.158 %
Empirical estimate 1 − 0.06/(0.34 − f)69.231 %
Share of mixed-juice sugar in primary juice64.286 %
Primary juice extraction from juice analyses61.393 %

Open this example in the calculator and change any input.

Formula

\(e' = \frac{m - f}{m(1 - f)}, \quad e = \min(1, \alpha e'), \quad e_{1,est} = 1 - \frac{0.06}{0.34 - f}, \quad x = \frac{S_1(S_m - S_2)}{S_m(S_1 - S_2)}, \quad e_1 = x\,e\)

Variables

Symbol Meaning SI unit
\(f\) Fibre per unit cane -
\(m\) Fibre in first-mill bagasse -
\(\alpha\) Sugar/juice extraction ratio -
\(S_1\) Sugar % primary juice -
\(S_2\) Sugar % secondary juice -
\(S_m\) Sugar % mixed juice -
\(e\) Total extraction of the tandem -
\(e'\) Juice extraction by dry crushing -
\(e_{1,est}\) Empirical estimate 1 − 0.06/(0.34 − f) -
\(x\) Share of mixed-juice sugar in primary juice -
\(e_1\) Primary juice extraction from juice analyses -

Method and standards

Hugot's dry-crushing balance and his empirical and juice-analysis methods.

Where it is used

  • Monitoring the first mill.
  • Weekly chemical control.

Common mistakes

  • Using mixed-juice sugar as primary juice sugar.
  • Entering fibre as a percent number.

Assumptions and limits

  • No losses between mills.
  • The empirical estimate is not shown where it gives zero or less (fibre above 28 %); the sugar extraction is capped at 100 % with a note.

References

  • Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (Elsevier, 1986)
  • ch. 19
  • eqns 19.3–19.4
  • pp. 282–283; ch. 21
  • eqns 21.1–21.6
  • pp. 328–330

Questions and answers

Why does first-mill extraction matter so much?

Everything it leaves must be recovered by the harder wet crushing; Hugot shows the total follows it closely.

Typical values?

60 % minimum, 70 % readily, 75–80 % with good preparation and feeding.

When is the juice-analysis method valid?

Only if third-mill juice does not mix with second-mill juice before the sampling point.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.