FireCADCalc

Mill Extraction from the Pol Balance

Pol % cane, pol in mixed juice and in bagasse % cane, and mill extraction from mixed juice and bagasse quantities and their pol.

Sugar mill and cogeneration

Inputs

Examples: Typical tandemHigh fibre cane

Results

Use net mixed juice (after the drit correction) for mixed juice % cane.

Pol in mixed juice % cane13.125%
Pol in bagasse % cane0.52200%
Pol % cane (by balance)13.647%
Mill extraction (pol in juice / pol in cane)96.175%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Typical tandem. The inputs, in the units selected above:

InputValue
Mixed juice % cane (net, after the drit correction)105.00 %
Pol % mixed juice12.500 %
Bagasse % cane29.000 %
Pol % bagasse1.8000 %

Applying the formula below gives:

ResultValue
Pol in mixed juice % cane13.125 %
Pol in bagasse % cane0.52200 %
Pol % cane (by balance)13.647 %
Mill extraction (pol in juice / pol in cane)96.175 %

Open this example in the calculator and change any input.

Formula

\(Pol_c = Pol_{MJ}\,MJ + Pol_B\,B, \quad ME = \frac{Pol_{MJ}\,MJ}{Pol_c}\)

Variables

Symbol Meaning SI unit
\(MJ\) Mixed juice % cane -
\(Pol_{MJ}\) Pol % mixed juice -
\(B\) Bagasse % cane -
\(Pol_{B}\) Pol % bagasse -
\(Pol_{MJ,c}\) Pol in mixed juice % cane -
\(Pol_{B,c}\) Pol in bagasse % cane -
\(Pol_c\) Pol % cane -
\(ME\) Mill extraction (pol in juice / pol in cane) -

Method and standards

Pol balance over the mill.

Where it is used

  • Shift and daily mill control.
  • Comparing milling tandems.

Common mistakes

  • Gross mixed juice weight used.
  • Bagasse % cane guessed instead of balanced.

Assumptions and limits

  • Steady crush; pol by routine methods.
  • Mixed juice must be the net weight after the drit correction; gross juice overstates pol % cane and extraction.
  • Pol % cane here is by balance, not by direct cane analysis.

References

  • Sugar factory chemical control (daily manufacturing report) definitions
  • as compiled in SugarProcessTech
  • Formulas for calculating sugar industry DMR

Questions and answers

Why is pol % cane computed and not measured?

Direct cane analysis is slow; the balance of juice and bagasse gives it every shift.

Is extraction the same as reduced extraction?

No: reduced extraction corrects to 12.5 % fibre so mills with different cane compare fairly.

Which mixed juice weight?

The net weight after the drit (suspended solids) correction.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.