Worked example
Example: Top roller, Reunion rate. The inputs, in the units selected above:
| Input | Value |
|---|---|
| New roller diameter (mean) | 0.91400 m |
| Wear rate on the diameter per 100 000 t cane | 3.1000 mm |
| Cane crushed per season | 600,000 t |
| Allowed wear as a share of the diameter | 5.0000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Diameter lost per season | 18.600 mm |
| Diameter at the end of the season | 895.40 mm |
| Seasons to the wear limit | 2.4570 |
Open this example in the calculator and change any input.
Formula
\(\Delta D = w\,\frac{C}{10^5\ \mathrm{t}}, \quad D_e = D - \Delta D, \quad n_s = \frac{\delta D}{\Delta D}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(D\) | New roller diameter (mean) | m |
| \(w\) | Wear rate on the diameter per 100 000 t cane | m |
| \(C\) | Cane crushed per season | kg |
| \(\delta\) | Allowed wear as a share of the diameter | - |
| \(\Delta D\) | Diameter lost per season | m |
| \(D_e\) | Diameter at the end of the season | m |
| \(n_s\) | Seasons to the wear limit | - |
Method and standards
Linear wear with tonnage.
Where it is used
- Planning re-shelling and re-grooving.
- Comparing roller materials and hard-facing.
Common mistakes
- Mixing wear on the radius and on the diameter.
- Using wear per 10 000 t.
Assumptions and limits
- Wear proportional to cane crushed. A season wear above the allowed wear is flagged, and wear larger than the roller itself is rejected.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 9
- roller wear
- pp. 113–115
Questions and answers
Which roller wears fastest?
The top roller; Hugot's Réunion figures put feed rollers at about 60 % and delivery rollers at 90 % of the top-roller wear.
What is the wear limit?
Classically 4–5 % of the mean diameter, up to 10 % in modern practice before re-shelling.
Does wear change capacity?
Yes: capacity falls with D², and the speed for the same surface speed must rise.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.