FireCADCalc

Mill Inclined Housings: Opening Change with Lift (Hugot)

How the feed and delivery openings change when the top roller lifts in inclined mill housings, and the ratio μ between them (Hugot eqns 13.9–13.10).

Sugar mill and cogeneration

Inputs

Examples: Hugot exampleSteeper housing

Results

With inclined housings the delivery opens more than the feed as the roller lifts: Hugot's example (α/2 = 33.5°, β = 15°) gives μ = 0.7.

Feed / delivery opening change ratio0.69873
Feed opening increase6.6262mm
Delivery opening increase9.4832mm
Increase of either opening with vertical housings8.3389mm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Hugot example. The inputs, in the units selected above:

InputValue
Top roller angle (between feed and delivery roller centres)67.000 °
Inclination of the housings from the vertical (towards the feed side)15.000 °
Lift of the top roller10.000 mm

Applying the formula below gives:

ResultValue
Feed / delivery opening change ratio0.69873
Feed opening increase6.6262 mm
Delivery opening increase9.4832 mm
Increase of either opening with vertical housings8.3389 mm

Open this example in the calculator and change any input.

Formula

\(\mu = \frac{\cos(\alpha/2 + \beta)}{\cos(\alpha/2 - \beta)}, \quad \Delta E = \Delta h\cos(\alpha/2 + \beta), \quad \Delta e = \Delta h\cos(\alpha/2 - \beta)\)

Variables

Symbol Meaning SI unit
\(\alpha\) Top roller angle (between feed and delivery roller centres) rad
\(\beta\) Inclination of the housings from the vertical rad
\(\Delta h\) Lift of the top roller m
\(\mu\) Feed / delivery opening change ratio -
\(\Delta E\) Feed opening increase m
\(\Delta e\) Delivery opening increase m
\(\Delta e_v\) Increase of either opening with vertical housings m

Method and standards

Geometry of the lift along the inclined housing.

Where it is used

  • Setting mills with inclined housings.
  • Understanding opening changes under load.

Common mistakes

  • Using the full angle α instead of α/2.
  • Measuring β from the horizontal.

Assumptions and limits

  • Small lifts; roller centres fixed otherwise.
  • β is measured from the vertical towards the feed side, so that the delivery opens more than the feed; α/2 + β must stay below 90°.

References

  • Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (Elsevier, 1986)
  • ch. 13
  • eqns 13.9–13.10
  • pp. 214–216

Questions and answers

Why incline the housings?

So the top roller lifts along the resultant of the forces on it; the delivery then opens more than the feed.

What is μ?

The ratio of the feed opening change to the delivery opening change for the same lift.

Vertical housings?

Both openings change by Δh cos(α/2).

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.