Worked example
Example: 914 x 1829 mill. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Roller diameter | 0.91400 m |
| Roller length | 1.8290 m |
| Standard roller diameter | 0.76200 m |
| Standard roller length | 1.5240 m |
| Crushing rate | 200.00 t/h |
Applying the formula below gives:
| Result | Value |
|---|---|
| Reduction ratio L_sD_s²/(LD²) | 0.57915 |
| Mill size relative to standard | 1.7267 |
| Crushing rate per standard mill size | 115.83 t/h |
Open this example in the calculator and change any input.
Formula
\(r = \frac{L_s D_s^2}{L D^2}, \quad A_s = A\,r\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(D\) | Roller diameter | m |
| \(L\) | Roller length | m |
| \(D_s\) | Standard roller diameter | m |
| \(L_s\) | Standard roller length | m |
| \(A\) | Crushing rate | kg/s |
| \(r\) | Reduction ratio L_sD_s²/(LD²) | - |
| \(1/r\) | Mill size relative to standard | - |
| \(A_s\) | Crushing rate per standard mill size | kg/s |
Method and standards
Hugot's geometric reduction.
Where it is used
- Comparing tandems in different factories.
- Benchmarking crush rates.
Common mistakes
- Using L D instead of L D².
- Comparing different speeds without correction.
Assumptions and limits
- Same speed and preparation. Hugot's capacity formula also has a speed factor n(1 − 0.06 n D), which this geometric reduction leaves out; mills of different diameter at the same rpm therefore are not compared on equal terms.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 12
- eqn 12.7
- p. 194
Questions and answers
Why D² and not D?
Capacity scales with length times diameter squared in Hugot's formula, so the reduction uses L D².
Why 762 × 1524 mm?
The classic 30 × 60 inch mill, Hugot's reference size.
Is speed included?
No: this is a geometric reduction; compare speeds separately.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.