Worked example
Example: Steam at 1 atm, 10 K, 1 m wall. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Steam pressure (absolute) | 1.0132 bar |
| Saturation minus wall temperature | 10.000 K |
| Height of the surface | 1.0000 m |
| Width or tube circumference | 0.10000 m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Saturation temperature | 99.974 °C |
| Modified latent heat h_fg + 0.68 c_p ΔT | 2,285.2 kJ/kg |
| Average condensing coefficient | 6,418.4 W/(m²·K) |
| Heat transferred | 6.4184 kW |
| Condensate formed | 10.111 kg/h |
Open this example in the calculator and change any input.
Formula
\(\bar h = 0.943\left[\frac{\rho_l(\rho_l - \rho_v) g\, h'_{fg}\, k_l^3}{\mu_l L (T_{sat} - T_w)}\right]^{1/4}, \quad h'_{fg} = h_{fg} + 0.68 c_{p,l}\Delta T\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(p\) | Steam pressure (absolute) | Pa |
| \(\Delta T\) | Saturation minus wall temperature | K |
| \(L\) | Height of the surface | m |
| \(W\) | Width or tube circumference | m |
| \(T_{sat}\) | Saturation temperature | K |
| \(h'_{fg}\) | Modified latent heat h_fg + 0.68 c_p ΔT | J/kg |
| \(\bar h\) | Average condensing coefficient | W/(m²·K) |
| \(\dot Q\) | Heat transferred | W |
| \(\dot m\) | Condensate formed | kg/s |
Method and standards
Nusselt's laminar film analysis.
Where it is used
- Condensers, heaters and steam-heated walls.
- Heat transfer examinations.
Common mistakes
- Superheated steam treated as saturated.
- Ignoring non-condensables.
Assumptions and limits
- Pure saturated steam, laminar wave-free film. The film Reynolds number Re_δ = 4ṁ/(μ_l b) is checked: above 30 (wavy-laminar) the result is conservative and a note appears.
References
- W. Nusselt (1916) film condensation; Incropera
- DeWitt
- Bergman and Lavine
- Fundamentals of Heat and Mass Transfer
- ch. 10 (0.943 coefficient, h'fg = h_fg + 0.68 c_p ΔT)
- IAPWS-IF97 (water and steam)
Questions and answers
Steam at 1 atm on a 1 m wall 10 K colder?
About 6 400 W/(m²·K) average.
Why so high?
Latent heat is released at the surface through a thin liquid film.
What lowers it in practice?
Air in the steam: a few per cent halves the coefficient.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.