FireCADCalc

TMP Refiner Heat Recovery: Clean Steam from Refiner Power

Steam released by thermomechanical pulp refiners from their motor power and the share recoverable as clean steam in a reboiler, with the steam per tonne of pulp.

Pulp and paper

Inputs

Examples: 20 MW for 500 t/dPressurised refiner 30 MW

Results

Specific refining energy900.00kWh/t
Refiner steam generated44.780t/h
Clean steam recovered33.585t/h
Recovered steam per OD tonne1.0076kg/kg

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 20 MW for 500 t/d. The inputs, in the units selected above:

InputValue
Refiner motor power20.000 MW
Pulp production (oven-dry)500.00 t/d
Share of power appearing as steam90.000 %
Share recovered as clean steam (reboiler)70.000 %
Latent heat of the steam2,100.0 kJ/kg

Applying the formula below gives:

ResultValue
Specific refining energy960.00 kWh/t
Refiner steam generated30.857 t/h
Clean steam recovered21.600 t/h
Recovered steam per OD tonne1.0368 kg/kg

Open this example in the calculator and change any input.

Formula

\(\dot m_s = \frac{P\phi}{h_{fg}}, \quad \dot m_r = \eta_r\dot m_s\)

Variables

Symbol Meaning SI unit
\(P\) Refiner motor power W
\(\dot m_{OD}\) Pulp production (oven-dry) kg/s
\(\phi\) Share of power appearing as steam -
\(\eta_r\) Share recovered as clean steam (reboiler) -
\(h_{fg}\) Latent heat of the steam J/kg
\(E\) Specific refining energy J/kg
\(\dot m_{s}\) Refiner steam generated kg/s
\(\dot m_{r}\) Clean steam recovered kg/s
\(\dot m_r/\dot m_{OD}\) Recovered steam per OD tonne kg/kg

Method and standards

Energy balance on the refiners.

Where it is used

  • TMP mill heat recovery design.

Common mistakes

  • Assuming all refiner steam is usable without a reboiler.

Assumptions and limits

  • Refiner heat leaves as saturated steam: only the latent heat is counted. Superheat in the refiner steam and the sensible heat of the dilution water are not included.

References

  • Smook
  • Handbook for Pulp & Paper Technologists
  • 3rd ed. (Angus Wilde, 2002)
  • ch. 5.6 (TMP: most of the refining energy appears as steam, recovered in reboilers)

Questions and answers

Why does refining make steam?

Nearly all the motor power ends up as heat that boils the water in the chips.

Why a reboiler?

Refiner steam is contaminated with turpentine and fibre; a reboiler makes clean steam from it.

How much steam per tonne?

Often 1.5–2 t of clean steam per tonne of TMP.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.