FireCADCalc

Paper Machine Section Draws

Draw (speed difference) between successive paper machine sections, as a percentage of the earlier section's speed, and the cumulative draw from wire to reel.

Pulp and paper

Inputs

Examples: 1200 / 1224 / 1236 / 1242 m/minBoard machine

Results

Open draws need enough tension to keep the sheet straight but not so much that wet paper breaks.

Draw wire → press2.0000%
Draw press → dryers0.98039%
Draw dryers → reel0.48544%
Total draw wire → reel3.5000%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 1200 / 1224 / 1236 / 1242 m/min. The inputs, in the units selected above:

InputValue
Wire speed1,200.0 m/min
Press section speed1,224.0 m/min
Dryer section speed1,236.0 m/min
Reel speed1,242.0 m/min

Applying the formula below gives:

ResultValue
Draw wire → press2.0000 %
Draw press → dryers0.98039 %
Draw dryers → reel0.48544 %
Total draw wire → reel3.5000 %

Open this example in the calculator and change any input.

Formula

\(d = \frac{v_{i+1}}{v_i} - 1, \quad d_t = \frac{v_r}{v_w} - 1\)

Variables

Symbol Meaning SI unit
\(v_w\) Wire speed m/s
\(v_p\) Press section speed m/s
\(v_d\) Dryer section speed m/s
\(v_r\) Reel speed m/s
\(d_{wp}\) Draw wire → press -
\(d_{pd}\) Draw press → dryers -
\(d_{dr}\) Draw dryers → reel -
\(d_t\) Total draw wire → reel -

Method and standards

Draw definitions.

Where it is used

  • Machine tuning.
  • Break analysis.

Common mistakes

  • Comparing draws at different speeds without %.
  • Reading drive speeds instead of sheet speeds.

Assumptions and limits

  • Steady running.
  • A negative draw (a section slower than the one before) is flagged.

References

  • Smook
  • Handbook for Pulp & Paper Technologists
  • 3rd ed. (Angus Wilde, 2002)
  • ch. 16–17 (sheet transfer and draws between sections)
  • Definitions and mass and energy balances

Questions and answers

Why is there a draw?

Wet paper stretches; each section runs slightly faster to keep the sheet taut.

What draws are usual?

1–3 % at the first press open draw, smaller later.

Why does the reel run fastest?

The sheet keeps stretching and the reel must hold tension.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.