Worked example
Example: 50 t OD wood, 15 % EA, 4 m3/t. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Wood charged (oven-dry) | 50,000 kg |
| Chip moisture (wet basis) | 45.000 % |
| Effective alkali charge on OD wood (as Na₂O) | 15.000 % |
| White liquor effective alkali (as Na₂O) | 100.00 g/L |
| Target liquor-to-wood ratio | 4.0000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Effective alkali required | 7,500.0 kg |
| White liquor volume | 75.000 m³ |
| Water in the chips | 40.909 m³ |
| Black liquor (or water) to make up the ratio | 84.091 m³ |
Open this example in the calculator and change any input.
Formula
\(EA = EA\% \times W, \quad V_{WL} = \frac{EA}{c_{WL}}, \quad V_{chip} = \frac{W m_c}{(1 - m_c)\rho_w}, \quad V_{BL} = (L/W)\,W - V_{WL} - V_{chip}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(W\) | Wood charged (oven-dry) | kg |
| \(m_c\) | Chip moisture (wet basis) | - |
| \(EA\%\) | Effective alkali charge on OD wood (as Na₂O) | - |
| \(c_{WL}\) | White liquor effective alkali (as Na₂O) | kg/m³ |
| \(L/W\) | Target liquor-to-wood ratio | - |
| \(EA\) | Effective alkali required | kg |
| \(V_{WL}\) | White liquor volume | m³ |
| \(V_{chip}\) | Water in the chips | m³ |
| \(V_{BL}\) | Black liquor (or water) to make up the ratio | m³ |
Method and standards
Mass balance of the digester charge.
Where it is used
- Batch digester charging.
- Continuous digester liquor ratios.
Common mistakes
- Basing the charge on wet chips.
- Mixing EA and AA.
Assumptions and limits
- Water density 1 000 kg/m³; liquor volumes additive.
- The liquor-to-wood ratio is a volume ratio (m³ per OD tonne). A ratio specified by mass (t/t) must be converted with the liquor density, or the black liquor make-up is off by 10–20 %.
References
- Smook
- Handbook for Pulp & Paper Technologists
- 3rd ed. (Angus Wilde, 2002)
- ch. 7 (kraft pulping: alkali charge on wood and liquor-to-wood ratio)
Questions and answers
Why charge on oven-dry wood?
Alkali consumption depends on the wood substance, not its water.
What charge is typical?
13–18 % effective alkali as Na₂O on OD wood for softwood bleachable grades.
Why add black liquor?
To reach the liquor-to-wood ratio needed to cover the chips without diluting the alkali with fresh water.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.