Worked example
Example: 1000 t/d mill. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Production | 1,000.0 t/d |
| Fresh water intake | 1,250.0 m³/h |
| Effluent flow | 1,041.7 m³/h |
| Effluent BOD | 30.000 mg/L |
| Effluent COD | 150.00 mg/L |
| Effluent TSS | 40.000 mg/L |
Applying the formula below gives:
| Result | Value |
|---|---|
| Water intake per tonne | 30.000 m³/t |
| Effluent per tonne | 25.000 m³/t |
| BOD load per tonne | 0.75000 kg/t |
| COD load per tonne | 3.7500 kg/t |
| TSS load per tonne | 1.0000 kg/t |
Open this example in the calculator and change any input.
Formula
\(w = \frac{\dot V_{in}}{P}, \quad \frac{BOD}{t} = \frac{\dot V_e c_{BOD}}{P}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(P\) | Production | kg/s |
| \(\dot V_{in}\) | Fresh water intake | m³/s |
| \(\dot V_{e}\) | Effluent flow | m³/s |
| \(c_{BOD}\) | Effluent BOD | kg/m³ |
| \(c_{COD}\) | Effluent COD | kg/m³ |
| \(c_{TSS}\) | Effluent TSS | kg/m³ |
| \(w\) | Water intake per tonne | m³/kg |
| \(e\) | Effluent per tonne | m³/kg |
| \(BOD/t\) | BOD load per tonne | kg/kg |
| \(COD/t\) | COD load per tonne | kg/kg |
| \(TSS/t\) | TSS load per tonne | kg/kg |
Method and standards
Load definitions.
Where it is used
- Environmental reporting.
- Water reduction programmes.
Common mistakes
- Mixing ADt and tonnes of paper.
- Using intake instead of effluent for loads.
Assumptions and limits
- Daily averages.
- The per-tonne figures are on whatever production basis is entered (air-dry tonnes ADt, oven-dry ODt or net saleable product); compare them only with benchmarks on the same basis.
References
- Smook
- Handbook for Pulp & Paper Technologists
- 3rd ed. (Angus Wilde, 2002)
- ch. 25 (mill water supply) and ch. 26 (effluent: BOD, COD and suspended solids)
Questions and answers
What water use is good?
Modern integrated mills use 10–30 m³/t; older mills over 100 m³/t.
Why per tonne?
Permits and benchmarks compare mills by load per tonne of product.
Is BOD in mg/L the same as g/m³?
Yes, so flow in m³ times mg/L gives grams.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.