Worked example
Example: 1070 x 2130 mill, 5 rpm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Roller mean diameter | 1.0700 m |
| Roller speed | 5.0000 rpm |
| Roller length | 2.1300 m |
| Work opening | 12.000 mm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Roller surface speed | 16.808 m/min |
| Escribed volume | 25.776 m³/h |
| Hugot maximal peripheral speed 33D/(D + 0.73) | 19.617 m/min |
| Hugot maximal roller speed | 5.8357 rpm |
| Hugot economic peripheral speed 30D/(D + 0.73) | 17.833 m/min |
Open this example in the calculator and change any input.
Formula
\(v = \pi D n, \quad \dot V = v L g\)
\(V_M = \frac{33D}{D + 0.73}, \quad n_M = \frac{V_M}{\pi D} = \frac{10.5}{D + 0.73}, \quad V_E = \frac{30D}{D + 0.73} \;[\mathrm{m/min};\ D\ \mathrm{m}]\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(D\) | Roller mean diameter | m |
| \(n\) | Roller speed | 1/s |
| \(L\) | Roller length | m |
| \(g\) | Work opening | m |
| \(v\) | Roller surface speed | m/s |
| \(\dot V\) | Escribed volume | m³/s |
| \(V_M\) | Hugot maximal peripheral speed 33D/(D + 0.73) | m/s |
| \(n_M\) | Hugot maximal roller speed | 1/s |
| \(V_E\) | Hugot economic peripheral speed 30D/(D + 0.73) | m/s |
Method and standards
Kinematics.
Where it is used
- Mill setting.
- Capacity checks.
Common mistakes
- rpm entered as rev/s.
Assumptions and limits
- Rigid rollers.
- Hugot's maximal and economic speeds are shown only for diameters of 0.6–1.5 m, and a note compares the surface speed with the maximal speed.
References
- v = π D n; escribed volume = v L g (Hugot, Handbook of Cane Sugar Engineering, milling)
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (1986)
- ch. 11
- eqns 11.5–11.9 (maximal and economic speeds)
- pp. 178–185
Questions and answers
Typical surface speed?
Around 12–20 m/min for most tandems.
Why escribed volume?
It links mill setting to the fibre the mill must pass.
Mean diameter?
Use the mean between groove tops and bottoms.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.