FireCADCalc

Cane Carrier Speed

Speed a cane carrier must run to deliver a crushing rate from the carrier width, cane bed height and loose cane bulk density.

Sugar mill and cogeneration

Inputs

Examples: 250 TCH carrierNarrow carrier

Results

Hugot: carrier speed about half the mill peripheral speed (0.3–0.5 of it); bulk density 150 kg/m³ tangled, 175 parallel, 300 after knives.

Carrier speed11.023m/min
Cane load per metre of carrier378.00kg/m

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 250 TCH carrier. The inputs, in the units selected above:

InputValue
Crushing rate250.00 t/h
Carrier width2.1000 m
Cane bed height1.0000 m
Cane bulk density on the carrier180.00 kg/m³

Applying the formula below gives:

ResultValue
Carrier speed11.023 m/min
Cane load per metre of carrier378.00 kg/m

Open this example in the calculator and change any input.

Formula

\(v = \frac{C}{\rho_b W H}, \quad q_L = \rho_b W H = \frac{C}{v}\)

Variables

Symbol Meaning SI unit
\(C\) Crushing rate kg/s
\(W\) Carrier width m
\(H\) Cane bed height m
\(\rho_b\) Cane bulk density on the carrier kg/m³
\(v\) Carrier speed m/s
\(q_L\) Cane load per metre of carrier kg/m

Method and standards

Continuity.

Where it is used

  • Cane handling design.
  • Feed control setting.

Common mistakes

  • Prepared-cane density for whole cane.

Assumptions and limits

  • Uniform bed.

References

  • Continuity v = ṁ/(ρ W H); bulk density by measurement
  • Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (1986)
  • ch. 2
  • eqns 2.3–2.8 and bulk densities
  • pp. 22–26

Questions and answers

Bulk density of cane?

Whole stalk cane on a carrier is roughly 150–250 kg/m³; prepared cane is denser.

Why a steady bed?

Even feeding keeps the mills loaded and extraction steady.

Kicker and leveller?

They set the bed height this calculation assumes.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.