Worked example
Example: First set, 50 mm pitch. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Crushing rate | 250.00 t/h |
| Carrier speed | 8.0000 m/min |
| Carrier width | 2.0000 m |
| Bulk density of the cane reaching the knives | 150.00 kg/m³ |
| Knife pitch (spacing along the shaft) | 50.000 mm |
| Clearance between knife tips and carrier | 300.00 mm |
| Knife tip circle diameter | 1.6000 m |
| Knife shaft speed | 600.00 rpm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Height of the cane layer | 1,736.1 mm |
| Number of knives (even) | 38.000 |
| Share of the layer passing uncut | 17.280 % |
| Share of the layer cut | 82.720 % |
| Knife tip speed | 50.265 m/s |
Open this example in the calculator and change any input.
Formula
\(h = \frac{A}{u\,L\,d}, \quad N = \left\lfloor \frac{L}{p} - 1 \right\rfloor\ \text{rounded down to even}, \quad i = \min\left(1, \frac{r}{h}\right), \quad K = 1 - i, \quad v_t = \pi D_k n\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(A\) | Crushing rate | kg/s |
| \(u\) | Carrier speed | m/s |
| \(L\) | Carrier width | m |
| \(d\) | Bulk density of the cane reaching the knives | kg/m³ |
| \(p\) | Knife pitch (spacing along the shaft) | m |
| \(r\) | Clearance between knife tips and carrier | m |
| \(D_k\) | Knife tip circle diameter | m |
| \(n\) | Knife shaft speed | 1/s |
| \(h\) | Height of the cane layer | m |
| \(N\) | Number of knives (even) | - |
| \(i\) | Share of the layer passing uncut | - |
| \(K\) | Share of the layer cut | - |
| \(v_t\) | Knife tip speed | m/s |
Method and standards
Hugot's continuity of the cane layer on the carrier and the geometry of the knife clearance.
Where it is used
- Specifying knife sets and their settings.
- Checking the cut achieved after a crush increase.
Common mistakes
- Taking the layer height after levelling as the height of tangled cane.
- Using the shaft speed in rpm in the SI form.
Assumptions and limits
- Even layer across the carrier width. With a clearance of at least the layer height nothing is cut (a note says so). A note appears outside 400–720 rpm.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 3
- eqns 3.1–3.4
- pp. 37–41
Questions and answers
Why an even number of knives?
Knives are mounted in opposed pairs to balance the rotor; Hugot rounds an odd count down to the next even number.
How close should the first set run?
Hugot puts the first-set clearance near a quarter of the layer height; closer settings cut more cane but need more power.
Which bulk density?
Whole tangled cane on the carrier is about 150 kg/m³; after a first set it packs to about 300 kg/m³.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.