Worked example
Example: First mill chute. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Height of bagasse in the chute | 2.5000 m |
| Bulk density of the bagasse in the chute | 400.00 kg/m³ |
| Chute angle to the horizontal | 80.000 ° |
| Friction coefficient of bagasse on the plates | 0.27000 - |
| Delivery work opening of the mill | 20.000 mm |
| Chute thickness / delivery opening | 16.000 - |
| Roller diameter | 1.0000 m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Feed pressure at the chute foot | 9.1979 kPa |
| Recommended chute thickness at the bottom | 320.00 mm |
| Thickness / roller diameter | 0.32000 |
Open this example in the calculator and change any input.
Formula
\(F = Z\,d\,g\,(\sin\beta - \varphi\cos\beta), \quad E = m\,e_A, \quad \frac{E}{D}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(Z\) | Height of bagasse in the chute | m |
| \(d\) | Bulk density of the bagasse in the chute | kg/m³ |
| \(\beta\) | Chute angle to the horizontal | rad |
| \(\varphi\) | Friction coefficient of bagasse on the plates | - |
| \(e_A\) | Delivery work opening of the mill | m |
| \(m\) | Chute thickness / delivery opening | - |
| \(D\) | Roller diameter | m |
| \(F\) | Feed pressure at the chute foot | Pa |
| \(E\) | Recommended chute thickness at the bottom | m |
| \(E/D\) | Thickness / roller diameter | - |
Method and standards
Hugot's static balance of the bagasse column on an inclined plate.
Where it is used
- Designing and checking Donnelly chutes.
- Diagnosing poor mill feeding.
Common mistakes
- Using whole-cane density for prepared bagasse.
- Taking the chute angle from the vertical.
Assumptions and limits
- Static column; no pressure feeder.
- A note flags E/D outside Hugot's practical 0.40–0.75.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 8
- eqns 8.6–8.9 and recommended thicknesses
- pp. 84–88
Questions and answers
What drives the feed?
The weight of the bagasse column, less the friction on the chute plates, pushes the blanket into the feed nip.
Why relate the thickness to the delivery opening?
The chute must pass the same fibre as the mill; Hugot gives the thickness as a multiple of the delivery opening.
Best chute angle?
Close to vertical; Hugot finds about 80° best, with the front plate a degree flatter.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.