Worked example
Example: Hugot final mill example. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Coefficient k (kW per tonne-force, rpm and metre) | 0.14500 - |
| Total hydraulic load | 340.00 tf |
| Roller speed | 5.0000 rpm |
| Roller diameter | 0.81300 m |
| Crushing rate | 100.00 t/h |
| Fibre % cane | 14.500 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Mill power at the rollers | 200.40 kW |
| Murry torque number G/(F D) | 0.14119 |
| Power per tonne fibre per hour | 13.821 kWh/t |
Open this example in the calculator and change any input.
Formula
\(P = k\,F\,n\,D \;[\mathrm{kW};\ F\ \mathrm{t};\ n\ \mathrm{rpm};\ D\ \mathrm{m}], \quad N_M = \frac{G}{F D} = \frac{P}{2\pi n F D}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(k\) | Coefficient k (kW per tonne-force, rpm and metre) | - |
| \(F\) | Total hydraulic load | N |
| \(n\) | Roller speed | 1/s |
| \(D\) | Roller diameter | m |
| \(A\) | Crushing rate | kg/s |
| \(f\) | Fibre % cane | - |
| \(P\) | Mill power at the rollers | W |
| \(N_M\) | Murry torque number G/(F D) | - |
| \(P/(A f)\) | Power per tonne fibre per hour | J/kg |
Method and standards
Hugot's simplified mill power and Murry's torque number.
Where it is used
- Quick sizing of mill drives.
- Comparing mill loads.
Common mistakes
- Using the horsepower k with kW.
- Load in kN in the tonne form.
Assumptions and limits
- Hugot's coefficients for 3-roller mills.
- With P = k F n D the Murry torque number reduces to N_M = 60k/(2πg) ≈ 0.974 k (k in kW per tonne-force, rpm and metre): it restates k in dimensionless form rather than adding information.
- The default k = 0.145 reproduces Hugot's final-mill example (about 200 kW); normal running values in his table are about 0.15–0.20.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 14
- eqns 14.9 and 14.11–14.12 and Table 14.8
- pp. 234–237
Questions and answers
Why is power proportional to F n D?
Torque is roughly proportional to the load times the roller radius, and power is torque times speed.
What is the Murry number?
Torque divided by load times diameter; a dimensionless measure that compares mills of any size.
Which k?
Hugot's Table 14.8 gives k by mill position, preparation and feeding; the first mill takes the most.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.