Worked example
Example: Hugot example 1000 rpm, 42.5 : 1, 21/104. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Motor or turbine-reducer output speed | 1,000.0 rpm |
| Reducer ratio | 42.500 - |
| Final pinion teeth | 21.000 - |
| Final gear (spur wheel) teeth | 104.00 - |
| Top roller diameter | 0.76200 m |
| Pitch diameter of the final gear | 2.4000 m |
Applying the formula below gives:
| Result | Value |
|---|---|
| Roller speed | 4.7511 rpm |
| Overall reduction | 210.48 |
| Roller surface speed | 11.374 m/min |
| Pitch-line speed of the final gear | 35.823 m/min |
Open this example in the calculator and change any input.
Formula
\(i = i_1\frac{z_2}{z_1}, \quad n = \frac{n_m}{i}, \quad v = \pi D n, \quad v_g = \pi d_g n\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(n_m\) | Motor or turbine-reducer output speed | 1/s |
| \(i_1\) | Reducer ratio | - |
| \(z_1\) | Final pinion teeth | - |
| \(z_2\) | Final gear (spur wheel) teeth | - |
| \(D\) | Top roller diameter | m |
| \(d_g\) | Pitch diameter of the final gear | m |
| \(n\) | Roller speed | 1/s |
| \(i\) | Overall reduction | - |
| \(v\) | Roller surface speed | m/s |
| \(v_g\) | Pitch-line speed of the final gear | m/s |
Method and standards
Gear train kinematics.
Where it is used
- Checking drive trains after a speed change.
- Choosing pinion and gear teeth.
Common mistakes
- Inverting the tooth ratio.
- Using the pinion diameter for the roller-shaft gear.
Assumptions and limits
- Rigid gear train; no slip. Notes compare the final pair with Hugot's limits (pitch-line speed and 5 : 1 per spur stage); the reducer's own stages are not checked.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 17
- mill gearing
- pp. 253–258 (example: 1000 rpm, 42.5 : 1 reducer, 21/104 final pair)
Questions and answers
How many stages?
Motors at 485–730 rpm need about 125 : 1 to reach 3–6 rpm, usually three stages; turbines add a high-speed reducer.
Why count teeth, not diameters?
The ratio of a gear pair is fixed by its teeth; pitch diameters follow from the module.
Is pitch-line speed a limit here?
Not for the slow final gear; it matters for the faster spur stages, which Hugot limits to about 700–825 m/min.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.