Worked example
Example: Second mill. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Working delivery opening | 21.000 mm |
| Feed / delivery opening ratio | 1.9000 - |
| Empty / working delivery opening | 0.40000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Working feed opening | 39.900 mm |
| Empty (setting) delivery opening | 8.4000 mm |
| Empty (setting) feed opening, vertical housings | 27.300 mm |
Open this example in the calculator and change any input.
Formula
\(E_A = m\,e_A, \quad s_0 = \psi\,e_A, \quad E_0 = s_0 + E_A - e_A\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(e_A\) | Working delivery opening | m |
| \(m\) | Feed / delivery opening ratio | - |
| \(\psi\) | Empty / working delivery opening | - |
| \(E_A\) | Working feed opening | m |
| \(s_0\) | Empty (setting) delivery opening | m |
| \(E_0\) | Empty (setting) feed opening, vertical housings | m |
Method and standards
Hugot's setting ratios.
Where it is used
- Setting mills at the start of season.
- Checking settings after re-grooving.
Common mistakes
- Using the empty opening as the working opening.
- Forgetting wear allowances.
Assumptions and limits
- Vertical housings; inclined housings need the correction of Hugot eqn 13.10.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 13
- eqns 13.6–13.7 and Tables 13.2–13.4
- pp. 205–214
Questions and answers
Why is the feed opening larger?
Bagasse enters loose and leaves compressed; the feed opening must pass the uncompressed blanket.
What is the empty setting?
The opening with the mill stopped and empty; under load the top roller lifts and opens it.
Where do the ratios come from?
Practice in Java, Hawaii and Europe as tabulated by Hugot.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.