FireCADCalc

Share of Juice from the Feed Roller

Share of a mill's juice expressed at the feed roller from the brix of feed-roller, delivery-roller and mill juice (Hugot eqn 21.16), and the two juice flows.

Sugar mill and cogeneration

Inputs

Examples: Last millIntermediate mill

Results

Hawaii practice: a last mill works well when 70–80 % of its juice comes from the feed roller; later mills about three-quarters.

The feed and delivery brixes differ by only 2.0 points: an error of 0.1 brix in any reading moves the share by about 5 percentage points.

Share of juice from the feed roller75.000%
Feed-roller juice45.000t/h
Delivery-roller juice15.000t/h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Last mill. The inputs, in the units selected above:

InputValue
Brix of feed-roller juice4.5000 %
Brix of delivery-roller juice6.5000 %
Brix of the mill's juice5.0000 %
Juice from the mill60.000 t/h

Applying the formula below gives:

ResultValue
Share of juice from the feed roller75.000 %
Feed-roller juice45.000 t/h
Delivery-roller juice15.000 t/h

Open this example in the calculator and change any input.

Formula

\(x = \frac{S - M}{S - E}\)

Variables

Symbol Meaning SI unit
\(E\) Brix of feed-roller juice -
\(S\) Brix of delivery-roller juice -
\(M\) Brix of the mill's juice -
\(\dot m_j\) Juice from the mill kg/s
\(x\) Share of juice from the feed roller -
\(\dot m_f\) Feed-roller juice kg/s
\(\dot m_d\) Delivery-roller juice kg/s

Method and standards

Brix balance of the two roller juices.

Where it is used

  • Checking individual mill work.
  • Setting feed openings.

Common mistakes

  • Sampling juices at different times.
  • Including returned juice in the samples.

Assumptions and limits

  • Juice samples taken together under steady load.
  • The share is very sensitive to brix errors when the feed and delivery brixes are close, as they often are at the last mills; a note gives the sensitivity, and another compares the share with Hawaii's 70–80 %.

References

  • Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (Elsevier, 1986)
  • ch. 21
  • eqn 21.16
  • p. 337

Questions and answers

Why should the feed roller give most of the juice?

It squeezes out the imbibition water on the outside of the bagasse; the delivery roller works on the inner cells.

Why is feed juice weaker in wet mills?

It is mostly the water just added; delivery juice comes from inside the cells and is richer.

What if x is low?

Check the feed opening and trashplate, and how the imbibition is applied.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.