FireCADCalc

Thickener (Decker) Balance: Filtrate and Fibre Loss

Thickened stock and filtrate flows of a decker or disc thickener from inlet and outlet consistency and filtrate consistency, with fibre lost to the filtrate.

Pulp and paper

Inputs

Examples: 500 t/h 0.8 % to 12 %Disc filter save-all

Results

Thickened stock39.239t/h
Filtrate760.76t/h
Fibre in the filtrate1.8258t/d
Fibre retention98.098%

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 500 t/h 0.8 % to 12 %. The inputs, in the units selected above:

InputValue
Stock in500.00 t/h
Inlet consistency0.80000 %
Outlet consistency12.000 %
Filtrate consistency0.030000 %

Applying the formula below gives:

ResultValue
Thickened stock32.164 t/h
Filtrate467.84 t/h
Fibre in the filtrate3.3684 t/d
Fibre retention96.491 %

Open this example in the calculator and change any input.

Formula

\(\dot m_{out} = \dot m_{in}\frac{C_{in} - C_f}{C_{out} - C_f}, \quad \dot m_f = \dot m_{in} - \dot m_{out}, \quad \dot m_{f,OD} = \dot m_f C_f, \quad R = \frac{\dot m_{out}C_{out}}{\dot m_{in}C_{in}}\)

Variables

Symbol Meaning SI unit
\(\dot m_{in}\) Stock in kg/s
\(C_{in}\) Inlet consistency -
\(C_{out}\) Outlet consistency -
\(C_f\) Filtrate consistency -
\(\dot m_{out}\) Thickened stock kg/s
\(\dot m_f\) Filtrate kg/s
\(\dot m_{f,OD}\) Fibre in the filtrate kg/s
\(R\) Fibre retention -

Method and standards

Total and fibre balances.

Where it is used

  • Thickener and save-all design.
  • Fibre loss audits.

Common mistakes

  • Ignoring filtrate fines.
  • Using % and fractions together.

Assumptions and limits

  • Steady state.

References

  • Smook
  • Handbook for Pulp & Paper Technologists
  • 3rd ed. (Angus Wilde, 2002)
  • ch. 9.6 (thickening)

Questions and answers

Why does filtrate consistency matter?

Fibre in the filtrate is lost or must be recovered in a save-all.

What outlet consistencies are reached?

Gravity deckers 4–8 %, disc thickeners and presses 10–30 %.

Is the balance exact?

Yes, from total and fibre balances; the consistencies must be measured together.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.