FireCADCalc

Pressure Screen Mass Balance and Reject Rate

Accept and reject flows, mass and volumetric reject rates and fibre losses of a pressure screen from feed, accept and reject consistencies and the reject flow split.

Pulp and paper

Inputs

Examples: 300 t/h at 3 %Fine screen

Results

Reject stock flow35.294t/h
Accept stock flow264.71t/h
Volumetric (flow) reject rate11.765%
Mass (fibre) reject rate17.647%
Thickening factor C_R/C_F1.5000

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 300 t/h at 3 %. The inputs, in the units selected above:

InputValue
Feed stock flow300.00 t/h
Feed consistency3.0000 %
Accept consistency2.8000 %
Reject consistency4.5000 %

Applying the formula below gives:

ResultValue
Reject stock flow35.294 t/h
Accept stock flow264.71 t/h
Volumetric (flow) reject rate11.765 %
Mass (fibre) reject rate17.647 %
Thickening factor C_R/C_F1.5000

Open this example in the calculator and change any input.

Formula

\(\dot m_R = \dot m_F\frac{C_F - C_A}{C_R - C_A}, \quad R_V = \frac{\dot m_R}{\dot m_F}, \quad R_M = \frac{\dot m_R C_R}{\dot m_F C_F}\)

Variables

Symbol Meaning SI unit
\(\dot m_F\) Feed stock flow kg/s
\(C_F\) Feed consistency -
\(C_A\) Accept consistency -
\(C_R\) Reject consistency -
\(\dot m_R\) Reject stock flow kg/s
\(\dot m_A\) Accept stock flow kg/s
\(R_V\) Volumetric (flow) reject rate -
\(R_M\) Mass (fibre) reject rate -
\(T_F\) Thickening factor C_R/C_F -

Method and standards

Total and fibre balances.

Where it is used

  • Screen room audits.
  • Cascade design.

Common mistakes

  • Using volumetric reject rate as fibre loss.
  • Consistency samples taken at different times.

Assumptions and limits

  • Steady state; stock density constant.

References

  • Smook
  • Handbook for Pulp & Paper Technologists
  • 3rd ed. (Angus Wilde, 2002)
  • ch. 9.4 (screening: reject rate on mass and volume basis)

Questions and answers

Why two reject rates?

Volumetric reject rate is what the operator sets; mass reject rate is the fibre actually lost to the next stage.

Why do rejects thicken?

Water passes the screen plate more easily than fibre, so rejects leave at higher consistency.

Why measure three consistencies?

Two balances (total and fibre) with three consistencies fix the flows.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.