Worked example
Example: 2400 t/d at 72 %. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Heavy black liquor flow | 2,400.0 t/d |
| Dry solids content | 72.000 % |
| Heating value of the dry solids | 14.000 MJ/kg |
| Boiler efficiency (on HHV of solids) | 65.000 % |
| Enthalpy rise feedwater to steam | 2,900.0 kJ/kg |
| Pulp production (oven-dry) | 1,000.0 t/d |
Applying the formula below gives:
| Result | Value |
|---|---|
| Dry solids fired | 1,728.0 t/d |
| Heat input | 280.00 MW |
| Steam generated | 225.93 t/h |
| Dry solids per OD tonne of pulp | 1.7280 kg/kg |
| Steam per OD tonne of pulp | 5.4223 kg/kg |
Open this example in the calculator and change any input.
Formula
\(\dot m_{DS} = \dot m_{BL}x, \quad Q = \dot m_{DS}HHV, \quad \dot m_s = \frac{\eta Q}{\Delta h}, \quad DS/\text{pulp} = \frac{\dot m_{DS}}{\dot m_{OD}}, \quad \text{steam}/\text{pulp} = \frac{\dot m_s}{\dot m_{OD}}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot m_{BL}\) | Heavy black liquor flow | kg/s |
| \(x\) | Dry solids content | - |
| \(HHV\) | Heating value of the dry solids | J/kg |
| \(\eta\) | Boiler efficiency (on HHV of solids) | - |
| \(\Delta h\) | Enthalpy rise feedwater to steam | J/kg |
| \(\dot m_{OD}\) | Pulp production (oven-dry) | kg/s |
| \(\dot m_{DS}\) | Dry solids fired | kg/s |
| \(Q\) | Heat input | W |
| \(\dot m_s\) | Steam generated | kg/s |
| \(DS/\text{pulp}\) | Dry solids per OD tonne of pulp | kg/kg |
| \(\text{steam}/\text{pulp}\) | Steam per OD tonne of pulp | kg/kg |
Method and standards
Heat input and simple efficiency.
Where it is used
- Recovery capacity planning.
- Mill steam balances.
Common mistakes
- Using as-fired instead of dry solids.
- Applying power-boiler efficiencies.
Assumptions and limits
- Efficiency on dry-solids HHV.
- The per-pulp figures are per oven-dry tonne; multiply by 0.9 for per air-dry tonne (ADt), the basis of the usual 1.5–1.8 t solids per ADt.
References
- Smook
- Handbook for Pulp & Paper Technologists
- 3rd ed. (Angus Wilde, 2002)
- ch. 10 (chemical recovery: heavy black liquor at 70–75 % solids burnt in the recovery furnace)
Questions and answers
Why is efficiency lower than a power boiler's?
Water in the liquor, the endothermic reduction to sulphide and smelt heat losses.
What heating value has black liquor?
About 13.5–15 MJ/kg dry solids for softwood kraft.
How much steam per tonne of solids?
About 3–4 t of high-pressure steam.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.