Worked example
Example: 2 % peroxide (500 g/L solution) at 10 % consistency. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Pulp production (oven-dry) | 500.00 t/d |
| Chemical charge on OD pulp | 2.0000 % |
| Chemical solution strength | 500.00 g/L |
| Consistency of pulp entering the mixer | 12.000 % |
| Stage consistency | 10.000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Chemical | 416.67 kg/h |
| Chemical solution | 13.889 L/min |
| Dilution water after the solution | 33.889 t/h |
Open this example in the calculator and change any input.
Formula
\(\dot m_c = c\,\dot m_{OD}, \quad \dot V_s = \frac{\dot m_c}{s}, \quad \dot m_{dw} = \dot m_{OD}\left(\frac{1}{C_{st}} - \frac{1}{C_{in}}\right) - \rho_w\dot V_s\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\dot m_{OD}\) | Pulp production (oven-dry) | kg/s |
| \(c\) | Chemical charge on OD pulp | - |
| \(s\) | Chemical solution strength | kg/m³ |
| \(C_{in}\) | Consistency of pulp entering the mixer | - |
| \(C_{st}\) | Stage consistency | - |
| \(\dot m_c\) | Chemical | kg/s |
| \(\dot V_s\) | Chemical solution | m³/s |
| \(\dot m_{dw}\) | Dilution water after the solution | kg/s |
Method and standards
Fibre and water balances.
Where it is used
- Bleach plant operation.
Common mistakes
- Charging on air-dry pulp.
- Forgetting the solution water.
Assumptions and limits
- Solution density 1 kg/L.
- The charge and the solution strength must be on the same chemical basis (both as ClO₂, or both as active chlorine; they differ by 2.63 times).
- When the solution alone over-dilutes, or the stage is thicker than the incoming pulp, no dilution water is shown and a note explains why.
References
- Smook
- Handbook for Pulp & Paper Technologists
- 3rd ed. (Angus Wilde, 2002)
- ch. 11 (bleaching: charges on OD pulp at a stage consistency)
Questions and answers
Why charge on OD pulp?
Chemical demand scales with fibre, not with water.
Why medium consistency?
10–12 % stages use less steam and chemical and smaller towers than low consistency.
Does the solution dilute the pulp?
Yes; its volume is counted before adding dilution water.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.