Worked example
Example: Typical. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Sucrose % cane | 13.500 % |
| Sucrose % bagasse | 1.8000 % |
| Fibre % cane | 14.500 % |
| Fibre % bagasse | 49.000 % |
| Pol % juice extracted by the last roller | 2.6000 % |
Applying the formula below gives:
| Result | Value |
|---|---|
| Sucrose in bagasse % cane | 0.53265 % |
| Sucrose extracted % cane | 12.967 % |
| Extraction c/R | 96.054 % |
| Bagasse pol / last-roller juice pol | 0.69231 |
Open this example in the calculator and change any input.
Formula
\(\beta = \sigma\frac{f}{f'}, \quad c = R - \beta, \quad e = \frac{c}{R}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(R\) | Sucrose % cane | - |
| \(\sigma\) | Sucrose % bagasse | - |
| \(f\) | Fibre % cane | - |
| \(f'\) | Fibre % bagasse | - |
| \(s\) | Pol % juice extracted by the last roller | - |
| \(\beta\) | Sucrose in bagasse % cane | - |
| \(c\) | Sucrose extracted % cane | - |
| \(e\) | Extraction c/R | - |
| \(\sigma/s\) | Bagasse pol / last-roller juice pol | - |
Method and standards
Hugot's balance with constant fibre.
Where it is used
- Daily mill reports.
- Checking imbibition mixing at the last mill.
Common mistakes
- Using pol % juice for σ.
- Using bagasse % cane from an unbalanced weight.
Assumptions and limits
- Constant fibre through the mills.
- Sucrose and pol are used interchangeably, as in factory control (apparent sucrose = pol); σ/s compares a sucrose with a pol figure on that basis.
- Sucrose in bagasse must stay below sucrose in cane.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 21
- eqns 21.17 and 21.24
- pp. 337–341
Questions and answers
Why use fibre ratios?
Bagasse % cane equals fibre % cane over fibre % bagasse, so sucrose in bagasse % cane needs no bagasse weight.
What should bagasse pol be?
Below the last-roller juice pol: ideally half, usually about 0.7 of it.
Is this the same as mill extraction?
Yes when R is sucrose (or pol) % cane from the same balance.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.