FireCADCalc

Mill Roller Wear and Life (Hugot)

Diameter lost by a mill roller over a season from a wear rate per 100 000 t cane, and the seasons until it reaches the wear limit as a share of its diameter.

Sugar mill and cogeneration

Inputs

Examples: Top roller, Reunion rateTromp upper rate

Hugot (Réunion): feed 2.1, top 3.1, delivery 2.9 mm; Tromp 6.5–13 mm for all rollers.
Hugot: 4–5 % classically, up to 10 % in modern practice.

Results

Rollers in one mill should stay within about 3 % of each other in diameter (Java practice).

Diameter lost per season18.600mm
Diameter at the end of the season895.40mm
Seasons to the wear limit2.4570

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Top roller, Reunion rate. The inputs, in the units selected above:

InputValue
New roller diameter (mean)0.91400 m
Wear rate on the diameter per 100 000 t cane3.1000 mm
Cane crushed per season600,000 t
Allowed wear as a share of the diameter5.0000 %

Applying the formula below gives:

ResultValue
Diameter lost per season18.600 mm
Diameter at the end of the season895.40 mm
Seasons to the wear limit2.4570

Open this example in the calculator and change any input.

Formula

\(\Delta D = w\,\frac{C}{10^5\ \mathrm{t}}, \quad D_e = D - \Delta D, \quad n_s = \frac{\delta D}{\Delta D}\)

Variables

Symbol Meaning SI unit
\(D\) New roller diameter (mean) m
\(w\) Wear rate on the diameter per 100 000 t cane m
\(C\) Cane crushed per season kg
\(\delta\) Allowed wear as a share of the diameter -
\(\Delta D\) Diameter lost per season m
\(D_e\) Diameter at the end of the season m
\(n_s\) Seasons to the wear limit -

Method and standards

Linear wear with tonnage.

Where it is used

  • Planning re-shelling and re-grooving.
  • Comparing roller materials and hard-facing.

Common mistakes

  • Mixing wear on the radius and on the diameter.
  • Using wear per 10 000 t.

Assumptions and limits

  • Wear proportional to cane crushed. A season wear above the allowed wear is flagged, and wear larger than the roller itself is rejected.

References

  • Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (Elsevier, 1986)
  • ch. 9
  • roller wear
  • pp. 113–115

Questions and answers

Which roller wears fastest?

The top roller; Hugot's Réunion figures put feed rollers at about 60 % and delivery rollers at 90 % of the top-roller wear.

What is the wear limit?

Classically 4–5 % of the mean diameter, up to 10 % in modern practice before re-shelling.

Does wear change capacity?

Yes: capacity falls with D², and the speed for the same surface speed must rise.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.