Worked example
Example: Hugot p. 311: 130 TCH, 12.5 % fibre, 12.5 m/min. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Crushing rate | 130.00 t/h |
| Fibre % cane | 12.500 % |
| Roller speed | 4.9001 rpm |
| Roller diameter | 0.81200 m |
| Roller length | 1.6760 m |
| Cane preparation | Two knife sets and a shredder (1.22) |
| Total rollers in the tandem | 15.000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Fibre loading | 12.928 kg/m² |
| Specific fibre loading q/D | 15.921 kg/m³ |
| Normal specific fibre loading (eqn 12.12) | 17.172 kg/m³ |
| Capacity ratio τ/τ₀ | 0.92712 |
| Peripheral speed | 12.500 m/min |
Open this example in the calculator and change any input.
Formula
\(q = \frac{A f}{\pi D n L}, \quad \tau = \frac{q}{D}, \quad \tau_0 = 4.774\,c\,(1 - 0.06\,nD)\sqrt N, \quad \theta = \frac{\tau}{\tau_0}\)
In the τ₀ formula n is in rpm and D in metres (the page converts n from 1/s); 4.774 is close to 15/π.
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(A\) | Crushing rate | kg/s |
| \(f\) | Fibre % cane | - |
| \(n\) | Roller speed | 1/s |
| \(D\) | Roller diameter | m |
| \(L\) | Roller length | m |
| \(c\) | Cane preparation | - |
| \(N\) | Total rollers in the tandem | - |
| \(q\) | Fibre loading | kg/m² |
| \(\tau\) | Specific fibre loading q/D | kg/m³ |
| \(\tau_0\) | Normal specific fibre loading (eqn 12.12) | kg/m³ |
| \(\theta\) | Capacity ratio τ/τ₀ | - |
| \(v\) | Peripheral speed | m/s |
Method and standards
Continuity of fibre through the roller surface and Hugot's normal loading.
Where it is used
- Checking mill loading against capacity.
- Setting mill openings.
Common mistakes
- Using rpm in the SI form of q.
- Using fibre % bagasse instead of % cane.
Assumptions and limits
- 3-roller mills at normal settings.
- The speed term (1 − 0.06 n D) takes n in rpm.
References
- Hugot
- Handbook of Cane Sugar Engineering
- 3rd ed. (Elsevier, 1986)
- ch. 12
- eqns 12.11–12.14
- pp. 195–197; worked example p. 311
Questions and answers
What is fibre loading?
Fibre passing per square metre of roller surface swept: the mass of fibre in the blanket per unit roller area.
Why divide by D?
Specific fibre loading q/D compares mills of different sizes; normal values lie near 15–20 kg/m³.
What does θ tell me?
The ratio of actual to Hugot's normal loading: above 1 the mill is pushed beyond its comfortable capacity.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.