FireCADCalc

Mill Capacity Reduced to a Standard Roller (Hugot)

Ratio that reduces a mill to Hugot's standard 762 × 1524 mm roller (eqn 12.7), and the crushing rate expressed on standard rollers, for comparing tandems.

Sugar mill and cogeneration

Inputs

Examples: 914 x 1829 mill1067 x 2134 mill

Results

Reduction ratio L_sD_s²/(LD²)0.57915
Mill size relative to standard1.7267
Crushing rate per standard mill size115.83t/h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 914 x 1829 mill. The inputs, in the units selected above:

InputValue
Roller diameter0.91400 m
Roller length1.8290 m
Standard roller diameter0.76200 m
Standard roller length1.5240 m
Crushing rate200.00 t/h

Applying the formula below gives:

ResultValue
Reduction ratio L_sD_s²/(LD²)0.57915
Mill size relative to standard1.7267
Crushing rate per standard mill size115.83 t/h

Open this example in the calculator and change any input.

Formula

\(r = \frac{L_s D_s^2}{L D^2}, \quad A_s = A\,r\)

Variables

Symbol Meaning SI unit
\(D\) Roller diameter m
\(L\) Roller length m
\(D_s\) Standard roller diameter m
\(L_s\) Standard roller length m
\(A\) Crushing rate kg/s
\(r\) Reduction ratio L_sD_s²/(LD²) -
\(1/r\) Mill size relative to standard -
\(A_s\) Crushing rate per standard mill size kg/s

Method and standards

Hugot's geometric reduction.

Where it is used

  • Comparing tandems in different factories.
  • Benchmarking crush rates.

Common mistakes

  • Using L D instead of L D².
  • Comparing different speeds without correction.

Assumptions and limits

  • Same speed and preparation. Hugot's capacity formula also has a speed factor n(1 − 0.06 n D), which this geometric reduction leaves out; mills of different diameter at the same rpm therefore are not compared on equal terms.

References

  • Hugot
  • Handbook of Cane Sugar Engineering
  • 3rd ed. (Elsevier, 1986)
  • ch. 12
  • eqn 12.7
  • p. 194

Questions and answers

Why D² and not D?

Capacity scales with length times diameter squared in Hugot's formula, so the reduction uses L D².

Why 762 × 1524 mm?

The classic 30 × 60 inch mill, Hugot's reference size.

Is speed included?

No: this is a geometric reduction; compare speeds separately.

Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.