FireCADCalc

Cutting Power from Specific Cutting Energy

Cutting power and motor power for a machining operation from the material removal rate, the specific cutting energy of the work material and the machine efficiency.

Inputs

Examples: Steel turningAluminium milling

From a table for the work material (W·s/mm³ = 10⁹ J/m³); carbon steels about 2–9 W·s/mm³.

Results

Cutting power4.0500kW
Motor power5.0625kW
Cutting force P_c/v_c1.3500kN

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Steel turning. The inputs, in the units selected above:

InputValue
Material removal rate90.000 cm³/min
Specific cutting energy2.7000e+09 J/m³
Machine efficiency80.000 %
Cutting speed (for the force)180.00 m/min

Applying the formula below gives:

ResultValue
Cutting power4.0500 kW
Motor power5.0625 kW
Cutting force P_c/v_c1.3500 kN

Open this example in the calculator and change any input.

Formula

\(P_c = Q\, u, \quad P_m = \frac{P_c}{\eta}, \quad F_c = \frac{P_c}{v_c}\)

Variables

Symbol Meaning SI unit
\(Q\) Material removal rate m³/s
\(u\) Specific cutting energy J/m³
\(\eta\) Machine efficiency -
\(v_c\) Cutting speed (for the force) m/s
\(P_c\) Cutting power W
\(P_m\) Motor power W
\(F_c\) Cutting force P_c/v_c N

Method and standards

Energy method.

Where it is used

  • Checking machine capacity.
  • Process planning.

Common mistakes

  • Units of u.
  • Ignoring tool wear (raises power).

Assumptions and limits

  • Sharp tool. The specific energy is taken as constant: it rises for thin chips and with tool wear, so correct the table value for your feed and allow for a worn tool.

References

  • P_c = Q u; P_m = P_c/η (Kalpakjian; Groover, specific energy method)

Questions and answers

90 cm³/min of steel at 2.7 W·s/mm³?

4.05 kW cutting, 5.06 kW at the motor.

Where is the specific energy?

Tables by material; it rises for small chip thickness.

Cutting force?

Power divided by cutting speed.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.