Worked example
Example: 180 m/min on 50 mm. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Value given | Cutting speed (find rpm) |
| Work (turning) or tool diameter | 50.000 mm |
| Cutting speed | 180.00 m/min |
| Spindle speed | 1,000.0 rpm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Spindle speed | 1,145.9 rpm |
| Cutting speed | 180.00 m/min |
Open this example in the calculator and change any input.
Formula
\(N = \frac{v_c}{\pi D}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(\text{given}\) | Value given | - |
| \(D\) | Work (turning) or tool diameter | m |
| \(v_c\) | Cutting speed | m/s |
| \(N\) | Spindle speed | 1/s |
Method and standards
Kinematics.
Where it is used
- Lathe, mill and drill set-up.
- Workshop examinations.
Common mistakes
- m/min vs m/s.
- Radius instead of diameter.
Assumptions and limits
- Rigid set-up.
References
- v_c = π D N
Questions and answers
180 m/min on a 50 mm bar?
About 1146 rpm.
Which diameter in turning?
The work diameter being cut; in milling and drilling, the tool diameter.
Facing?
Diameter falls towards the centre, so constant surface speed control raises rpm.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.