FireCADCalc

Tool Life by Taylor's Equation

Tool life at a cutting speed, or the speed for a target tool life, from Taylor's equation V T^n = C with your exponent and constant.

Inputs

Examples: Carbide at 150 m/minHSS at 30 m/min

About 0.1–0.15 for HSS, 0.2–0.3 for carbide, higher for ceramics.
Any speed unit (m/min, ft/min); the constant must be fitted with tool life in minutes.

Results

C is the speed giving a 1 min tool life: constants fitted with T in seconds or hours must be converted first.

Tool life at V50.568min
Speed for the target life170.91m/min

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Carbide at 150 m/min. The inputs, in the units selected above:

InputValue
Cutting speed150.00 m/min
Taylor exponent0.25000 -
Taylor constant: cutting speed for a 1 min tool life400.00 m/min
Target tool life30.000 min

Applying the formula below gives:

ResultValue
Tool life at V50.568 min
Speed for the target life170.91 m/min

Open this example in the calculator and change any input.

Formula

\(V T^n = C\)

Variables

Symbol Meaning SI unit
\(V\) Cutting speed m/s
\(n\) Taylor exponent -
\(C\) Taylor constant: cutting speed for a 1 min tool life m/s
\(T_t\) Target tool life s
\(T\) Tool life at V s
\(V_t\) Speed for the target life m/s

Method and standards

Taylor.

Where it is used

  • Tool change planning.
  • Machining economics.

Common mistakes

  • m/s with constants in m/min.
  • Extrapolating far beyond the data.

Assumptions and limits

  • C is the cutting speed that gives a 1 min tool life, so it can be entered in any speed unit; the equation is evaluated with V in m/min and T in minutes. Constants fitted with T in seconds or hours must be converted first.

  • Lives outside about 1–1000 min are flagged: small n makes T extremely sensitive to speed, and extrapolation beyond the fitted speeds is unreliable.

  • Same tool, work and feed as the constants.

References

  • Taylor (1907) V Tⁿ = C

Questions and answers

Carbide n 0.25, C 400, at 150 m/min?

About 51 minutes.

Speed for 30 min?

About 171 m/min.

Why does speed hurt so much?

Life varies as speed to the power −1/n: −4 for n = 0.25.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.