Worked example
Example: 25 to 20 mm hot strip. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Entry thickness | 25.000 mm |
| Exit thickness | 20.000 mm |
| Roll radius | 250.00 mm |
| Strip width | 300.00 mm |
| Mean flow stress in the pass | 180.00 MPa |
Applying the formula below gives:
| Result | Value |
|---|---|
| Draft | 5.0000 mm |
| Reduction | 20.000 % |
| Contact length √(RΔh) | 35.355 mm |
| Roll force σ̄ w L | 1,909.2 kN |
Open this example in the calculator and change any input.
Formula
\(\Delta h = h_0 - h_f, \quad L = \sqrt{R\Delta h}, \quad F = \bar\sigma w L\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(h_0\) | Entry thickness | m |
| \(h_f\) | Exit thickness | m |
| \(R\) | Roll radius | m |
| \(w\) | Strip width | m |
| \(\bar\sigma\) | Mean flow stress in the pass | Pa |
| \(\Delta h\) | Draft | m |
| \(r\) | Reduction | - |
| \(L\) | Contact length √(RΔh) | m |
| \(F\) | Roll force σ̄ w L | N |
Method and standards
Slab estimate.
Where it is used
- Rolling mill checks.
- Examinations.
Common mistakes
- Diameter for radius.
- Room-temperature flow stress for hot rolling.
Assumptions and limits
- Plane strain, no friction.
- The largest draft the rolls can bite, about μ²R, is not checked (no friction input), and roll flattening, which lengthens the contact under high force, is ignored.
References
- Flat rolling: L = √(RΔh)
- F ≈ σ̄ w L (Kalpakjian; Groover)
Questions and answers
25 to 20 mm, 250 mm rolls, 300 mm wide, 180 MPa?
Contact 35.4 mm: about 1909 kN.
Why smaller rolls for thin strip?
Contact length and force fall with roll radius.
Hot rolling?
Use the flow stress at the rolling temperature and strain rate.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.