Worked example
Example: 80 mm cup, 60 mm tall. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Cup diameter (mean) | 80.000 mm |
| Cup height | 60.000 mm |
| Trim allowance on height | 4.0000 mm |
| Limiting draw ratio, first draw | 2.0000 - |
| Limiting draw ratio for redraws (0 = same as the first) | 0 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Blank diameter | 163.95 mm |
| Total draw ratio | 2.0494 |
| Draws needed at the LDR | 2.0000 |
Open this example in the calculator and change any input.
Formula
\(D = \sqrt{d^2 + 4dh}, \quad n = 1 + \left\lceil\frac{\ln(D/(d\,LDR))}{\ln LDR_r}\right\rceil\ (D/d > LDR;\ \text{else}\ 1)\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(d\) | Cup diameter (mean) | m |
| \(h\) | Cup height | m |
| \(\Delta h\) | Trim allowance on height | m |
| \(LDR\) | Limiting draw ratio, first draw | - |
| \(LDR_r\) | Limiting draw ratio for redraws (0 = same as the first) | - |
| \(D\) | Blank diameter | m |
| \(D/d\) | Total draw ratio | - |
| \(n\) | Draws needed at the LDR | - |
Method and standards
Area equality.
Where it is used
- Pressed cups, cans and housings.
- Tool design.
Common mistakes
- Outside instead of mean diameter.
- One draw beyond the LDR.
Assumptions and limits
- Thin sheet, constant thickness.
- The first draw uses LDR and each redraw LDR_r (lower in practice); with LDR_r = 0 every draw uses LDR, which underestimates the count for tall cups.
References
- Surface-area equality for a thin cylindrical cup D = √(d² + 4dh); limiting draw ratio (Kalpakjian; Schuler, Metal Forming Handbook)
Questions and answers
80 mm cup, 60 mm tall with 4 mm trim?
Blank about 164 mm, ratio 2.05: just over an LDR of 2, so two draws (or a shallower first draw and a redraw).
Taller cups?
Need redraws, each at a smaller ratio.
Why trim allowance?
Earing leaves an uneven rim to cut off.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.