FireCADCalc

Strip Layout: Parts per Strip and Material Utilisation

Parts per strip and material utilisation for blanking from strip length and width, part length along the strip, part area and the bridge (web) between parts.

Inputs

Examples: 60 mm parts on 2.5 m stripWashers 40 mm

Results

Parts per strip39.000
Material utilisation62.400%
Pitch l_p + b63.000mm

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 60 mm parts on 2.5 m strip. The inputs, in the units selected above:

InputValue
Strip length2.5000 m
Strip width70.000 mm
Part length along the strip60.000 mm
Bridge between parts and at the ends3.0000 mm
Area of one part2,800.0 mm²

Applying the formula below gives:

ResultValue
Parts per strip39.000
Material utilisation62.400 %
Pitch l_p + b63.000 mm

Open this example in the calculator and change any input.

Formula

\(n = \left\lfloor\frac{L_s - b}{l_p + b}\right\rfloor, \quad \eta = \frac{n A_p}{L_s W_s}\)

Variables

Symbol Meaning SI unit
\(L_s\) Strip length m
\(W_s\) Strip width m
\(l_p\) Part length along the strip m
\(b\) Bridge between parts and at the ends m
\(A_p\) Area of one part m²
\(n\) Parts per strip -
\(\eta\) Material utilisation -
\(p\) Pitch l_p + b m

Method and standards

Layout geometry.

Where it is used

  • Press tool design.
  • Material costing.

Common mistakes

  • Ignoring end bridges.
  • Gross instead of net part area.

Assumptions and limits

  • Single-row layout.
  • The part width and the side bridges are not inputs: choose the strip width to include them. The calculator warns when the part area exceeds the pitch times the strip width.

References

  • Strip layout: n = ⌊(L − b)/(l + b)⌋
  • utilisation = n A/(L W)

Questions and answers

2.5 m strip, 60 mm parts with 3 mm bridges?

39 parts; utilisation 62 % for 2800 mm² parts.

Improve it?

Nest parts at an angle or in two rows.

Bridge width?

About the sheet thickness or more, per your tool standard.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.