FireCADCalc

Tap Drill Size and Thread Percentage (Metric and Unified)

Tap drill diameter for a target percentage of thread from the major diameter and pitch, and the thread percentage a given drill gives (cut taps).

Inputs

Examples: M8 x 1.25M12 x 1.75 at 70 %

Unified threads: pitch = 1/TPI (25.4 mm ÷ threads per inch, e.g. 1/4-20 UNC has 1.27 mm).

Results

For cutting taps on 60° threads; forming taps need a larger hole. Round to a drill you can buy.

Drill for the target6.7822mm
Thread percentage with the drill73.901

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: M8 x 1.25. The inputs, in the units selected above:

InputValue
Thread major diameter8.0000 mm
Pitch1.2500 mm
Target thread percentage75.000 -
Drill to check6.8000 mm

Applying the formula below gives:

ResultValue
Drill for the target6.7822 mm
Thread percentage with the drill73.901

Open this example in the calculator and change any input.

Formula

\(x = 76.98\,\frac{D - d}{P}, \quad d = D - \frac{x P}{76.98}\)

Variables

Symbol Meaning SI unit
\(D\) Thread major diameter m
\(P\) Pitch m
\(x\) Target thread percentage -
\(d_d\) Drill to check m
\(d_t\) Drill for the target m
\(x_d\) Thread percentage with the drill -

Method and standards

Thread geometry.

Where it is used

  • Drilling and tapping.
  • Workshop examinations.

Common mistakes

  • Using cut-tap drills for forming taps.
  • Pitch in threads per inch.

Assumptions and limits

  • Pitch is entered as a length; for Unified threads divide 25.4 mm by the threads per inch.

  • The page warns when the drill to check gives 0 % or less (drill at or above the major diameter) or more than 100 % thread.

  • 60° threads, cut taps.

References

  • % thread = 76.98 (D − d)/P for 60° threads (machinists' practice; Machinery's Handbook)

Questions and answers

M8 × 1.25 at 75 %?

6.78 mm: use 6.8 mm.

Why not 100 %?

Above about 75 % strength barely rises but tapping torque and tap breakage climb.

Rule of thumb?

Major minus pitch gives about 77 % thread.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.