Worked example
Example: 63 mm, 6 teeth. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Feed per tooth | 0.10000 mm |
| Number of teeth | 6.0000 - |
| Cutter diameter | 63.000 mm |
| Cutting speed | 200.00 m/min |
Applying the formula below gives:
| Result | Value |
|---|---|
| Spindle speed | 1,010.5 rpm |
| Table feed | 606.30 mm/min |
Open this example in the calculator and change any input.
Formula
\(N = \frac{v_c}{\pi D}, \quad v_f = f_z\, z\, N\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(f_z\) | Feed per tooth | m |
| \(z\) | Number of teeth | - |
| \(D\) | Cutter diameter | m |
| \(v_c\) | Cutting speed | m/s |
| \(N\) | Spindle speed | 1/s |
| \(v_f\) | Table feed | m/s |
Method and standards
Kinematics.
Where it is used
- CNC programming.
- Workshop set-up.
Common mistakes
- Feed per revolution for feed per tooth.
- Wrong tooth count.
Assumptions and limits
- Full engagement. No spindle-speed limit of the machine and no chip-thinning correction (at radial engagement below half the diameter, raise f_z to keep the chip thickness).
References
- v_f = f_z z N; N = v_c/(πD)
Questions and answers
63 mm six-tooth cutter, 200 m/min, 0.1 mm/tooth?
About 1011 rpm and 606 mm/min.
Too small a chip?
Rubbing and fast wear; keep feed per tooth in the maker's range.
Chip thinning?
Light radial cuts need more feed per tooth for the same chip thickness.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.