Worked example
Example: PLA part 120 cm3. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Part volume | 120.00 mL |
| Infill density | 20.000 % |
| Share of volume in solid walls and skins | 30.000 % |
| Filament density | 1,240.0 kg/m³ |
| Filament diameter | 1.7500 mm |
| Average volumetric print rate | 0.30000 mL/min |
Applying the formula below gives:
| Result | Value |
|---|---|
| Material mass | 65.472 g |
| Filament length | 21.952 m |
| Print time | 2.9333 h |
Open this example in the calculator and change any input.
Formula
\(V_d = V[s + (1 - s)\phi], \quad m = \rho V_d, \quad L_f = \frac{V_d}{\pi d_f^2/4}, \quad t = \frac{V_d}{\dot V}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(V\) | Part volume | m³ |
| \(\phi\) | Infill density | - |
| \(s\) | Share of volume in solid walls and skins | - |
| \(\rho\) | Filament density | kg/m³ |
| \(d_f\) | Filament diameter | m |
| \(\dot V\) | Average volumetric print rate | m³/s |
| \(m\) | Material mass | kg |
| \(L_f\) | Filament length | m |
| \(t\) | Print time | s |
Method and standards
Volume balance.
Where it is used
- Spare parts, jigs and fixtures.
- Prototype costing.
Common mistakes
- Ignoring supports.
- Peak instead of average rate.
Assumptions and limits
- Average print rate.
References
- Volume balance: deposited volume = V(s + (1 − s)φ)
Questions and answers
120 cm³ part, 20 % infill, 30 % shells, PLA?
About 65 g, 22.0 m of filament, 2.9 h.
Why shells matter?
Walls and skins are solid; for small parts they are most of the volume.
Cost?
Mass × filament price plus machine time.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.