Worked example
Example: 0.2 mm/rev, 0.8 mm nose. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Feed per revolution | 0.20000 mm |
| Tool nose radius | 0.80000 mm |
| Target Ra | 1.6000 µm |
Applying the formula below gives:
| Result | Value |
|---|---|
| Theoretical Ra f²/(32r) | 1.5625 µm |
| Peak-to-valley f²/(8r) | 6.2500 µm |
| Feed for the target Ra | 0.20239 mm |
Open this example in the calculator and change any input.
Formula
\(R_a \approx \frac{f^2}{32 r_\varepsilon}, \quad R_t = \frac{f^2}{8 r_\varepsilon}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(f\) | Feed per revolution | m |
| \(r_\varepsilon\) | Tool nose radius | m |
| \(R_{a,t}\) | Target Ra | m |
| \(R_a\) | Theoretical Ra f²/(32r) | m |
| \(R_t\) | Peak-to-valley f²/(8r) | m |
| \(f_t\) | Feed for the target Ra | m |
Method and standards
Geometry.
Where it is used
- Finishing passes.
- Shaft journals and seal faces.
Common mistakes
- Expecting the theoretical value in practice.
- Feed in mm/min.
Assumptions and limits
R_a = f²/(32 r) is the usual approximation (R_a = R_t/4). The exact mean deviation of a circular-arc cusp is f²/(18√3 r) = f²/(31.2 r), about 2.6 % higher; the difference is far smaller than the effect of wear and vibration.
Valid when the feed is well below the nose radius; the page warns when f exceeds r and when f reaches 2r, where the nose arc no longer forms the whole cusp.
Sharp tool, no vibration.
References
- Geometric roughness R_t = f²/(8r)
- R_a ≈ f²/(32r) (Kalpakjian; Sandvik turning formulas)
Questions and answers
0.2 mm/rev with a 0.8 mm nose?
Ra about 1.56 µm.
Feed for Ra 1.6 µm?
About 0.20 mm/rev.
Wiper inserts?
They allow higher feed for the same finish.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.