FireCADCalc

Machining Time: Turning, Drilling, Milling

Cutting time for turning or drilling from length, feed, spindle speed and passes, or for milling from length, approach and table feed.

Inputs

Examples: Turning two passesFace milling 300 mm

Results

Cutting time only; add loading, tool changes and inspection for the cycle time.

Machining time1.4311min

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: Turning two passes. The inputs, in the units selected above:

InputValue
OperationTurning or drilling (feed per revolution)
Length of cut200.00 mm
Approach and overrun5.0000 mm
Feed per revolution0.25000 mm
Spindle speed1,146.0 rpm
Number of passes2.0000 -
Table feed (milling)1,819.0 mm/min

Applying the formula below gives:

ResultValue
Machining time1.4311 min

Open this example in the calculator and change any input.

Formula

\(t = \frac{L + L_a}{f N}n_p, \quad t = \frac{L + L_a}{v_f}n_p\)

Variables

Symbol Meaning SI unit
\(\text{operation}\) Operation -
\(L\) Length of cut m
\(L_a\) Approach and overrun m
\(f\) Feed per revolution m
\(N\) Spindle speed 1/s
\(n_p\) Number of passes -
\(v_f\) Table feed (milling) m/s
\(t_m\) Machining time s

Method and standards

Kinematics.

Where it is used

  • Job costing.
  • Process sheets.

Common mistakes

  • Ignoring approach.
  • Feed per tooth for feed per rev.

Assumptions and limits

  • Constant feed. The number of passes applies to milling as well as turning; only the inputs of the chosen operation are checked.

References

  • t = (L + L_a)/(f N) per pass; milling t = (L + L_a)/v_f

Questions and answers

200 mm at 0.25 mm/rev, 1146 rpm, two passes, 5 mm approach?

About 1.43 min.

Drilling allowance?

Add the drill point length (about 0.3 D for 118°) to the approach.

Milling approach?

Include half the cutter diameter for face milling.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.