Worked example
Example: Steel turning. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Material removal rate | 90.000 cm³/min |
| Specific cutting energy | 2.7000e+09 J/m³ |
| Machine efficiency | 80.000 % |
| Cutting speed (for the force) | 180.00 m/min |
Applying the formula below gives:
| Result | Value |
|---|---|
| Cutting power | 4.0500 kW |
| Motor power | 5.0625 kW |
| Cutting force P_c/v_c | 1.3500 kN |
Open this example in the calculator and change any input.
Formula
\(P_c = Q\, u, \quad P_m = \frac{P_c}{\eta}, \quad F_c = \frac{P_c}{v_c}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(Q\) | Material removal rate | m³/s |
| \(u\) | Specific cutting energy | J/m³ |
| \(\eta\) | Machine efficiency | - |
| \(v_c\) | Cutting speed (for the force) | m/s |
| \(P_c\) | Cutting power | W |
| \(P_m\) | Motor power | W |
| \(F_c\) | Cutting force P_c/v_c | N |
Method and standards
Energy method.
Where it is used
- Checking machine capacity.
- Process planning.
Common mistakes
- Units of u.
- Ignoring tool wear (raises power).
Assumptions and limits
- Sharp tool. The specific energy is taken as constant: it rises for thin chips and with tool wear, so correct the table value for your feed and allow for a worn tool.
References
- P_c = Q u; P_m = P_c/η (Kalpakjian; Groover, specific energy method)
Questions and answers
90 cm³/min of steel at 2.7 W·s/mm³?
4.05 kW cutting, 5.06 kW at the motor.
Where is the specific energy?
Tables by material; it rises for small chip thickness.
Cutting force?
Power divided by cutting speed.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.