Worked example
Example: 4 L casting. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Casting volume | 4.0000 L |
| Casting cooling surface area | 0.16000 m² |
| Mould constant (s/mm²) | 2.0000 - |
| Riser modulus / casting modulus | 1.2000 - |
| Riser height to diameter ratio | 1.0000 - |
Applying the formula below gives:
| Result | Value |
|---|---|
| Casting modulus V/A | 25.000 mm |
| Casting solidification time B M² | 20.833 min |
| Riser diameter | 180.00 mm |
| Riser height | 180.00 mm |
Open this example in the calculator and change any input.
Formula
\(t_s = B\left(\frac{V}{A}\right)^2, \quad M_r = k M_c, \quad D_r = M_r\,\frac{2 + 4r}{r}\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(V_c\) | Casting volume | m³ |
| \(A_c\) | Casting cooling surface area | m² |
| \(B\) | Mould constant (s/mm²) | - |
| \(k\) | Riser modulus / casting modulus | - |
| \(H/D\) | Riser height to diameter ratio | - |
| \(M_c\) | Casting modulus V/A | m |
| \(t_s\) | Casting solidification time B M² | s |
| \(D_r\) | Riser diameter | m |
| \(H_r\) | Riser height | m |
Method and standards
Chvorinov and modulus.
Where it is used
- Foundry method design.
- Examinations.
Common mistakes
- Area including faces in contact with the riser.
- Ignoring feed volume.
Assumptions and limits
- Sand casting, simple shapes.
- Side riser: the cylinder cools on its top, bottom and side (M = rD/(2 + 4r)). A top riser whose base sits on the casting, or one with an insulated top, has a larger modulus for the same size.
- Feed volume is not checked: the note gives the riser volume as a share of the casting for that check.
References
- Chvorinov (1940): t = B(V/A)²; riser modulus ≥ k × casting modulus
- cylinder modulus rD/(2 + 4r) (Campbell; Kalpakjian)
Questions and answers
4 L casting with 0.16 m² surface?
Modulus 25 mm, solidification about 21 min; riser about 180 mm diameter and height (H/D 1, factor 1.2).
Why must the riser freeze last?
It feeds liquid metal into the shrinking casting.
Mould constant?
From trial castings in your sand and alloy.
Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.