Worked example
Example: 1200 / 1224 / 1236 / 1242 m/min. The inputs, in the units selected above:
| Input | Value |
|---|---|
| Wire speed | 1,200.0 m/min |
| Press section speed | 1,224.0 m/min |
| Dryer section speed | 1,236.0 m/min |
| Reel speed | 1,242.0 m/min |
Applying the formula below gives:
| Result | Value |
|---|---|
| Draw wire → press | 2.0000 % |
| Draw press → dryers | 0.98039 % |
| Draw dryers → reel | 0.48544 % |
| Total draw wire → reel | 3.5000 % |
Open this example in the calculator and change any input.
Formula
\(d = \frac{v_{i+1}}{v_i} - 1, \quad d_t = \frac{v_r}{v_w} - 1\)
Variables
| Symbol | Meaning | SI unit |
|---|---|---|
| \(v_w\) | Wire speed | m/s |
| \(v_p\) | Press section speed | m/s |
| \(v_d\) | Dryer section speed | m/s |
| \(v_r\) | Reel speed | m/s |
| \(d_{wp}\) | Draw wire → press | - |
| \(d_{pd}\) | Draw press → dryers | - |
| \(d_{dr}\) | Draw dryers → reel | - |
| \(d_t\) | Total draw wire → reel | - |
Method and standards
Draw definitions.
Where it is used
- Machine tuning.
- Break analysis.
Common mistakes
- Comparing draws at different speeds without %.
- Reading drive speeds instead of sheet speeds.
Assumptions and limits
- Steady running.
- A negative draw (a section slower than the one before) is flagged.
References
- Smook
- Handbook for Pulp & Paper Technologists
- 3rd ed. (Angus Wilde, 2002)
- ch. 16–17 (sheet transfer and draws between sections)
- Definitions and mass and energy balances
Questions and answers
Why is there a draw?
Wet paper stretches; each section runs slightly faster to keep the sheet taut.
What draws are usual?
1–3 % at the first press open draw, smaller later.
Why does the reel run fastest?
The sheet keeps stretching and the reel must hold tension.
Method and article reviewed by FireCAD engineering on 13 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.