FireCADCalc

3D Printing: Material, Filament Length and Print Time

Material mass, filament length and print time for an FDM 3D print from the part volume, infill, shell share, filament density and diameter and volumetric rate.

Inputs

Examples: PLA part 120 cm3PETG bracket 40 cm3, 50 %

PLA about 1240 kg/m³, PETG 1270, ABS 1040.
Your printer's average including travel.

Results

Supports and brims add material; the slicer's estimate is better once you have it.

Material mass35.560g
Filament length11.641m
Print time1.9444h

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: PLA part 120 cm3. The inputs, in the units selected above:

InputValue
Part volume120.00 mL
Infill density20.000 %
Share of volume in solid walls and skins30.000 %
Filament density1,240.0 kg/m³
Filament diameter1.7500 mm
Average volumetric print rate0.30000 mL/min

Applying the formula below gives:

ResultValue
Material mass65.472 g
Filament length21.952 m
Print time2.9333 h

Open this example in the calculator and change any input.

Formula

\(V_d = V[s + (1 - s)\phi], \quad m = \rho V_d, \quad L_f = \frac{V_d}{\pi d_f^2/4}, \quad t = \frac{V_d}{\dot V}\)

Variables

Symbol Meaning SI unit
\(V\) Part volume m³
\(\phi\) Infill density -
\(s\) Share of volume in solid walls and skins -
\(\rho\) Filament density kg/m³
\(d_f\) Filament diameter m
\(\dot V\) Average volumetric print rate m³/s
\(m\) Material mass kg
\(L_f\) Filament length m
\(t\) Print time s

Method and standards

Volume balance.

Where it is used

  • Spare parts, jigs and fixtures.
  • Prototype costing.

Common mistakes

  • Ignoring supports.
  • Peak instead of average rate.

Assumptions and limits

  • Average print rate.

References

  • Volume balance: deposited volume = V(s + (1 − s)φ)

Questions and answers

120 cm³ part, 20 % infill, 30 % shells, PLA?

About 65 g, 22.0 m of filament, 2.9 h.

Why shells matter?

Walls and skins are solid; for small parts they are most of the volume.

Cost?

Mass × filament price plus machine time.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.