FireCADCalc

Press Brake Bending Force (V-Die)

Force to air-bend sheet in a V-die from tensile strength, bend length, thickness and die opening, with your die factor.

Inputs

Examples: 3 mm steel, 2 m, 24 mm die6 mm stainless, 1 m, 50 mm die

About 1.2–1.33 for V-dies, 0.3 for wiping dies, 0.7 for U-dies (Kalpakjian).
Often about 8 × thickness.

Results

Air bending; bottoming or coining needs several times more.

Bending force418.95kN
Force in tonne-force42.721

Download PDF CSV Link to this result Compare another case

Log in to save calculations to your dashboard.

Worked example

Example: 3 mm steel, 2 m, 24 mm die. The inputs, in the units selected above:

InputValue
Die factor1.3300 -
Tensile strength420.00 MPa
Bend length2.0000 m
Thickness3.0000 mm
Die opening24.000 mm

Applying the formula below gives:

ResultValue
Bending force418.95 kN
Force in tonne-force42.721

Open this example in the calculator and change any input.

Formula

\(F = \frac{k\, UTS\, L\, t^2}{W}, \quad P = \frac{F}{1000\,g}\ \text{(metric tonnes-force, } g = 9.806\,65\ \text{m/s}^2)\)

Variables

Symbol Meaning SI unit
\(k\) Die factor -
\(UTS\) Tensile strength Pa
\(L\) Bend length m
\(t\) Thickness m
\(W\) Die opening m
\(F\) Bending force N
\(P\) Force in tonne-force -

Method and standards

Beam bending with an empirical die factor.

Where it is used

  • Fabrication shops.
  • Selecting a press brake.

Common mistakes

  • Die opening too narrow for thickness.
  • Yield instead of tensile strength.

Assumptions and limits

  • Air bending; die opening of the usual proportion (about 8 t). A die narrower than the thickness gets a warning.

References

  • F = k UTS L t²/W (Kalpakjian, Manufacturing Engineering and Technology)

Questions and answers

2 m of 3 mm steel (420 MPa) in a 24 mm V-die?

About 419 kN (43 t).

Why does the die opening matter?

Force falls as the opening widens, but the inside radius grows.

Stainless?

Higher strength and work hardening: use its UTS.

Method and article reviewed by FireCAD engineering on 12 November 2026. Every result is checked against an independent calculation on each release: how we verify our calculators.

Related calculators

Free engineering calculators: every page computes in SI and converts to your units. Results are for engineering estimation; verify critical designs against the referenced standards.

Rejoining the server...

Rejoin failed... trying again in seconds.

Failed to rejoin.
Please retry or reload the page.

The session has been paused by the server.

Failed to resume the session.
Please retry or reload the page.